Telematics Wireless Ltd. T210A Benutzerhandbuch
10
◦
Attach antennas to DCU2 Pro E US.
◦
Place unit on pole and secure with steel tape.
◦
Drill hole at location on pole where power cable will enter and insert grommet.
◦
Insert 12 meter AC power cable from DCU2 Pro E US through grommet in pole.
◦
Connect end of 12 meter power cable to circuit breaker.
◦
Using the prepared Android smartphone, scan the barcode on the side of the DCU2 Pro E US
unit and test the communication to the CMS.
unit and test the communication to the CMS.
5.1.
Safety Guidelines
Before you begin the installation of, use, or perform any service operation on the DCU2 Pro E US, read
the following safety information.
the following safety information.
Attention to these warnings will help prevent personal injuries, and damage to the DCU2 Pro E US.
It is your responsibility to use the DCU2 Pro E US in an appropriate manner:
The DCU2 Pro E US is only for use on a stable and sturdy street light pole.
The DCU2 Pro E US must not be used in any way that may cause personal injury or property damage.
Make sure that the installation process including the pole selection is approved by a construction
engineer.
engineer.
You are responsible if the DCU2 Pro E US is used in any way other than its designed purpose, or contrary
to Telematics Wireless instructions. Telematics Wireless shall assume no responsibility for such use of
the DCU2 Pro E US.
to Telematics Wireless instructions. Telematics Wireless shall assume no responsibility for such use of
the DCU2 Pro E US.
The DCU2 Pro E US is used for its designated purpose only if it is used in accordance with its product
documentation and within its performance limits.
documentation and within its performance limits.
Using the DCU2 Pro E US requires technical skills, and a basic knowledge of English. It is therefore
essential that only skilled and specialized staff, or thoroughly trained personnel with the required skills,
be allowed to use the product.
essential that only skilled and specialized staff, or thoroughly trained personnel with the required skills,
be allowed to use the product.
Keep the basic safety instructions and the product documentation in a safe place, and make them
available to subsequent users.
available to subsequent users.
Note: Applicable local or national safety regulations and rules for the prevention of accidents
must be observed in all work performed.
Warning: This section contains general guidelines, and does not include every potentially hazardous
situation. When you install the DCU2 Pro E US, always use common sense and caution.
situation. When you install the DCU2 Pro E US, always use common sense and caution.
5.1.1.
General Safety Guidelines
The following safety guidelines should always be followed:
Never attempt to lift an object that might be too heavy for you to lift by yourself.
Always disconnect the power source and unplug all power cables before lifting or moving the DCU2
Pro E US components.
Pro E US components.