Estone Technology Inc. MRD85I Benutzerhandbuch

Seite von 26
 
B U T T O N   D E S C R I P T I O N  
 
 
The Yellow, Red and Black power wires should be 14AWG or larger 
depending on the length to the battery.    NEVER operate the unit 
without the proper power and ground wire.     
 
NEVER ground the speaker leads and NEVER allow the speaker 
leads to come in contact with each other. The speaker wire should 
be at least 16 gauge or larger.    Be sure to observe the correct 
polarity on the speaker connections 
 
Use quality crimp connectors to connect wires together. Seal the 
connection well with electrical tape. 
 
NEVER operate the unit without proper fusing. Fuse holder must be 
located  within  2  feet  from  the  battery.  This  fuse  is  to  protect  the 
vessel,  not  the  electronics.  In  case  of  a  short,  the  fuse  will  blow 
instead of the wire burning up. Using other than the recommended 
fuse ratings at the battery and at the unit may cause damage to the 
unit and will void your warranty. 
 
Whenever  possible,  use  cable  ties,  mounting  clamps  and  similar 
wiring  aids.  Adding  stress  relief  loop  to  wiring  is  also  advisable  to 
prevent straining or breakage. 
 
If after reading the directions you feel uncomfortable about installing 
the  unit,  or  not  equipped  or  competent  to  do  so,  you  should  have 
this installed by a professional installer