Parallels Workstation 2.2, 1000-1999u, FR, MNT WWL2XM-08-FR Benutzerhandbuch

When running a virtual machine with a network adapter you can: 

ƒ  connect/disconnect the network adapter, 
ƒ  switch between different adapters of your host computer and host-only networking mode. 

Note: If the guest OS is started with the network adapter disabled, you should shut down the 
guest OS first, then enable the network adapter in the Configuration Editor (select the Enabled 
check box in the Network Adapter Options (on page 119) tab) and restart the guest OS. 

To connect or disconnect network adapter, do the following: 

1  Select Devices->Network in Parallels Workstation menu. 

2  Select the Connect/Disconnect command to connect or disconnect network adapter 

respectively. 

Note. You may also connect/disconnect a network adapter using context menu of the network 
adapter device  

 on the status bar. 

To switch a network adapter of the virtual machine between bridged adapters: 

1  Check to what network adapter the virtual machine is now connected. 

To learn this point by mouse to the network adapter icon  

 on the status bar. The Mode 

line shows the type of networking: bridged ethernet or host-only; the Name line shows the 
name of the network adapter to which the virtual machine is connected. 

2  Set a different network adapter.  

For this right-click network adapter icon 

 on the status bar to display the context menu. 

Click the name of the desired adapter in the context menu. 

Note: You may also switch between adapters using commands in the Devices->Network menu.