Smart Communications Ltd SCU99BL Benutzerhandbuch
8
Battery- The BPSC1L -1is a rechargeable Nickel-Cadmium (Ni-Cad) type battery.
Battery Charging Jack-This jack is used to recharge the battery. The WCSC7 Wall
Charger (included with the Radio) will fully charge the battery in approximately 20 hours
if either the radio is turned off or the battery is removed from the Unit. Be sure to
reinstall the protective plug when the Charger is disconnected.
Belt Clip- When not using the belt-clip; install the mounting screws in order to help
ensure water resistance.
OPERATION
Each time the Unit changes modes or a key is pressed, a beep is heard. This feature can
be disabled by the Dealer.
TURNING UNIT ON
1. Rotate the ON/OFF/VOL knob clockwise to turn the power on.
2. Adjust the audio’s volume by turning the ON/OFF/VOL knob clockwise to increase
the audio output, or counter-clockwise to decrease it. If necessary, first turn the Squelch
(SQL) Control counter-clockwise until noise is heard. Then set the Volume Control to
the desired level.
3. Turn the Squelch Control (SQL) clockwise until “noise” is no longer heard
(squelched). The battery life is maximized if the Unit is squelched when not
receiving a signal. If the Unit is programmed for widely different receive
frequencies, the Squelch Control may require being turned slightly more clockwise
to a setting that permits proper squelch operation for all channels.
If the present Channel has been programmed for Busy Channel Lockout, “noise”
may not be heard from the speaker. If this is the case, select a channel without
BCL. If all channels have BCL, press the FUNC button until a burst of noise is
heard from the speaker. You may need to repeat this procedure until the desired
volume level is reached.
STATUS INDICATOR
The bi-color (red and green) TX/Busy LED provides a visual indication of the
radio’s operational status.
receiving a signal. If the Unit is programmed for widely different receive
frequencies, the Squelch Control may require being turned slightly more clockwise
to a setting that permits proper squelch operation for all channels.
If the present Channel has been programmed for Busy Channel Lockout, “noise”
may not be heard from the speaker. If this is the case, select a channel without
BCL. If all channels have BCL, press the FUNC button until a burst of noise is
heard from the speaker. You may need to repeat this procedure until the desired
volume level is reached.
STATUS INDICATOR
The bi-color (red and green) TX/Busy LED provides a visual indication of the
radio’s operational status.