Sea Air and Land Communications 1185 Benutzerhandbuch

11-85 UHF POCSAG TRANSMITTER OPERATOR’S MANUAL

Issue 1185UA 0104

11-85 UHF POCSAG TRANSMITTER OPERATOR’S MANUAL

Issue 1185UA 0104

Sea Air and Land Communications Ltd

Page 4

Sea Air and Land Communications Ltd

Page 5

If the 11-85 does not perform as required, the following points may lead to solving
the problem.

No LED illumination when button pressed

Bad power supply connection

Unit activates but no transmission

Configuration incorrect. Input not present for the
required debounce period.

Unit transmits but nothing received

Wrong RIC or POCSAG baud-rate. Supply too low.
Too much vibration. RF interference at receiver.

LED flashes rapidly during transmission

Indicates low battery voltage

The PSD software allows the user to configure the following characteristics:
Input actions, POCSAG and transmission settings, Pre-defined messages, RF
frequency.

Requirements:   To change the programmable options connect the 11-85 via a
SALCOM 11-46 serial programming adaptor from the programming plug P8 to the
serial port of a computer running terminal software 9600,n,8,1.   

  

1. Remove the 4 case screws and the

rear cover of the case. 

2. Connect a good 9 volt battery to

the 11-85 battery connector.

3. Insert the four pin socket of the

Salcom 11-46 programming header
into the 11-85 plug P8. (see photo
and diagram overleaf).

4. Connect the Salcom 11-46 DB25

plug to the PC comport.

5. Using the terminal program e.g.

Procomm the computer will display
the options that can be edited.

If the program fails to indicate communications to the 11-85, check the battery
and baud rate setting in your terminal software.