Hewlett Packard Enterprise AP3150 Benutzerhandbuch

The access point can be mounted on the following types of surfaces:

Wall, ceiling, or electrical box (NEMA enclosure)

Tabletop

Use the mounting bracket that comes with your access point to install it on a wall, ceiling, or 
electrical box.

To wall-mount the access point:

Route Ethernet cable through the opening in the cradle.

Screw the mounting bracket to a wall, ceiling, or electrical box (NEMA enclosure):

If mounting to a solid surface wall or ceiling, use the two sheet metal screws.

If mounting to drywall, use the two sheet metal screws and two wall anchors.

If mounting to an electrical box (NEMA enclosure), use the two threaded screws.

The figures below show a cable being routed through the large opening in the cradle and 
then the cradle being mounted to a wall. 

Connect the Ethernet cable (for power and network connection) to the port on the rear of 
the access point.

Twist the access point onto the mounting bracket.

To install the access point on a flat surface such as a table or desktop:

Remove the backing from the four rubber feet and attach them on the bottom of the access 
point.

Place the access point on the table.

Connect the Ethernet cable (for power and network connection) to the port on the rear of 
the access point.