Honeywell International Inc. 7400-352 Benutzerhandbuch
16
•
•
•
•
•
•
) ,-
Follow these steps to install the Dolphin 7400 battery pack.
1. The Dolphin 7400 ships with the handstrap installed. Hold the terminal with the
front panel (keyboard) facing down. Push the clip of the handstrap down and
away from the terminal to unhook it; move the strap up and away from the bat-
tery compartment.
away from the terminal to unhook it; move the strap up and away from the bat-
tery compartment.
2. Insert the end without the locking tab into the top of the battery opening and
snap the battery into place with a hinging motion. The battery case serves as
the back cover of the Dolphin.
the back cover of the Dolphin.
3. Reattach the handstrap by positioning it down over the battery case and sliding
the clip back into the place at the bottom end of the 7400.
4. The terminal will initialize and, after a few seconds, will show the splash screen
for the Dolphin 7400 demo program.
+
) ,-
Follow these directions to remove the Dolphin battery pack.
1. Hold the Dolphin with the front panel (keyboard) facing down.
2. Remove the handstrap by pushing its clip down and forward to unhook it from
the terminal; move the strap away from the battery compartment.
3. Push the locking tab on the battery pack up and pull the battery out from the
Dolphin terminal with a hinging motion.
&
)
0*0
)
0##
Turning on the Dolphin 7400 for the first time is a cold boot. Follow these steps to
turn on your Dolphin 7400 terminal.
turn on your Dolphin 7400 terminal.
1. Install the charged battery pack in the Dolphin.
2. The red LED will come on and the green LED will blink for approximately three
seconds.
NOTE: DO NOT PRESS ANY KEYS WHILE THE TERMINAL IS BOOTING
UP.
NOTE: DO NOT PRESS ANY KEYS WHILE THE TERMINAL IS BOOTING
UP.
3. The terminal will initialize and after a few seconds will display the Dolphin 7400
splash screen shown below: