Adtran TRC4106L2 Benutzerhandbuch
Section 5 User Interface Guide
TRACER 4106/4206 System Manual
48
© 2004 ADTRAN, Inc.
612804206L2-1A
>TRACER S
YSTEM
O
PTIONS
> RF B
ANDPLAN
Sets the bandplan for the TRACER 4106/4206. Each channel is divided into three bandplans (1, 2, or 3).
Both local and remote TRACER 4106/4206 must be configured with the same bandplan (1, 2, or 3) but
different channel plans (Plan A or Plan B). For example, the transmitter at one end of the link will transmit
in bandplan 1 of channel A (the lower portion of the spectrum) and receive in bandplan 1 of channel B (the
upper portion). Consequently, the receiver at the other end should receive in bandplan 1 of channel A (the
lower portion) and transmit in bandplan 1 of channel B (the upper portion). (Refer to Figures 5 and 6 for
the 2.4 GHz and 5.8 GHz bandwidth division, respectively.) The TRACER 4106/4206 comes factory
programmed with RF bandplan set to Band 1.
Both local and remote TRACER 4106/4206 must be configured with the same bandplan (1, 2, or 3) but
different channel plans (Plan A or Plan B). For example, the transmitter at one end of the link will transmit
in bandplan 1 of channel A (the lower portion of the spectrum) and receive in bandplan 1 of channel B (the
upper portion). Consequently, the receiver at the other end should receive in bandplan 1 of channel A (the
lower portion) and transmit in bandplan 1 of channel B (the upper portion). (Refer to Figures 5 and 6 for
the 2.4 GHz and 5.8 GHz bandwidth division, respectively.) The TRACER 4106/4206 comes factory
programmed with RF bandplan set to Band 1.
Figure 5. 2.4 GHz Bandwidth Division (TRACER 4106)
Figure 6. 5.8 GHz Bandwidth Division (TRACER 4206)
>TRACER S
YSTEM
O
PTIONS
>A
CTIVE
T1 P
ORTS
Configures the delivered bandwidth of the TRACER 4106/4206. When
4
X
T1
ports are active, the system
receive sensitivity is -90 dBm (TRACER 4106) and -85 dBm (TRACER 4206). As the delivered
bandwidth is decreased, receive sensitivity improves (see Table 1 on page 49).
bandwidth is decreased, receive sensitivity improves (see Table 1 on page 49).
When changing RF bandplans on installed links, change the remote end first. If the local
end is changed first, remote configuration capability is lost. In the event the local end is
changed first and the link is dropped, reset the local end to the previous setting to restore
the link.
end is changed first, remote configuration capability is lost. In the event the local end is
changed first and the link is dropped, reset the local end to the previous setting to restore
the link.
Channel A
2416
2441.75
2422
2428
2400 MHz
2483.5 MHz
Bandplan 3
Bandplan 2
Bandplan 1
Channel B
2456
2462
2468
Bandplan 3
Bandplan 2
Bandplan 1
Channel A
5734
5725
5787
5850
5744
5753
MHz
MHz
Bandplan 3
Bandplan 2
Bandplan 1
Channel B
5814
5824
5833
Bandplan 3
Bandplan 2
Bandplan 1