Adtran TRC4305 Benutzerhandbuch
Section 3, Engineering Guidelines
TRACER 4305 System Manual
26
© 2002 ADTRAN, Inc.
612804305L1A-1A
4.
REVIEWING THE TRACER 4305 REAR PANEL DESIGN
The TRACER 4305 rear panel contains the following interfaces:
•
A
LARM
interface (terminal block) for connecting to an external alarm monitoring system
•
DC P
OWER
(terminal block) for connecting to a proper 21-63 VDC power source
•
DS3 I
N
and
O
UT
(BNC interfaces) for connecting to a DS3 device
•
Antenna (N-Type connector) for the antenna feedline cable
•
Ground lug for connecting to earth ground
•
RS232
(DB-25 female) for connecting to a VT100 terminal or PC with terminal emulation software
Figure 2 on page 27 identifies the various features of the TRACER 4305 rear panel. A detailed discussion
of all interfaces (including pinouts, where applicable) follows the figure.
of all interfaces (including pinouts, where applicable) follows the figure.
AIS
Red (solid)
the TRACER 4305 received a remote alarm from a connected
DS3 device (properly aligned and framed alternating one-zero
pattern).
DS3 device (properly aligned and framed alternating one-zero
pattern).
LOF
Red (solid)
the TRACER 4305 DS3 framer has lost alignment (due to
receiving too many F or M bits in error).
receiving too many F or M bits in error).
LOS
Red (solid)
the TRACER 4305 does not detect a DS3 from the connected
DS3 device signal (indicated by receiving 192 consecutive
zeros).
DS3 device signal (indicated by receiving 192 consecutive
zeros).
BPV
Red (solid)
the TRACER 4305 detects Bipolar Violations on the received
signal from the connected DS3 device (receiving two
consecutive “one” bits with the same polarity).
signal from the connected DS3 device (receiving two
consecutive “one” bits with the same polarity).
LBK
Amber (solid)
the TRACER 4305 is currently in DS3 line loopback.
Amber (flashing)
the TRACER 4305 is currently in DS3 link loopback.
Table 2. TRACER 4305 LEDs (Continued)
For these LEDs...
This color light...
Indicates that...