Accton Technology SPW2MAC1200 Benutzerhandbuch

–  1  –

◆

Spark AC Wave2 Mini, SP-W2M-AC1200

◆

Universal AC/DC power adapter

◆

USB cable — Micro to Type A

◆

Cat 5e Ethernet cable, 1.2 m (4 ft)

◆

2 Med Command strips

◆

Quick Start Guide (this document)

At the installation location on the wall, mark two holes 
44 mm (1.73 in) apart for the wall plugs and screws (not 
included).
Drill two holes for the wall plugs, and then insert the plugs 
and tap them flush with the wall surface. 
Insert the two screws in the wall plugs leaving the screw 
heads about 5 mm from the wall surface.

With its ports facing down, place the AP’s mounting points 
over the two screws, and then slide it down on the screws.
Do not let go of the AP until you confirm that it is secure.

Position and stick the two supplied Med Command strips to 
the base of the AP as shown.
Position the AP on the wall and press firmly for 30 seconds.
Remove the AP from the wall to separate the strips. Wait a 
further hour before mounting the AP.
Mount the AP by pressing the strips together until they click.

1

2

2

1

1

2

1

1

1

Attach the included four rubber feet to the base of the AP.
Place the AP on the desktop.

Connect the cable from the AC/DC power adapter to the USB 
power jack on the AP.
Connect the power adapter to a nearby AC power source 
(100-240 VAC, 50/60 Hz).

Connect Category 5e or better cable to the 1000BASE-T 
Eth1 RJ-45 port.
Connect the other end of this cable to a LAN switch.

(Optional) Connect a local LAN device to the Eth2 RJ-45 port 
on the AP using Category 5e or better cable.
This Eth2 RJ-45 port is a 100BASE-TX port.

The power LED should be on green.

1

1

1

1

1

3

1

2

1

2

3

1

2

3

1

Spark SP-W2M-AC1200

E122017-CS  15020000

1xxxX

 R01

Cloud-Enabled Indoor Access Point

Spark™ AC Wave2 Mini, SP-W2M-AC1200

ignitenet.com