Accton Technology ML10G360 Benutzerhandbuch

–  1  –

◆

 

MetroLinq™ 10G Tri-Band Omni

◆

 

Pole-mount kit — bracket, 8 

bolts,

◆

 

13 mm socket wrench

◆

 

Flat-head screwdriver

◆

 

Ethernet cables

Attach the port cover to the base of the unit using the 

included four screws. 

Attach the mounting bracket to the base of the unit using 

four bolts.

Insert four bolts into the holes in the mounting bracket, 

leaving the heads a few millimeters from the bracket.

Feed the two steel-band clamps through the pole-mount 

bracket mounting points.

Fasten the steel-band clamps around the pole to secure the 

pole-mount bracket to the pole.

3

1

2

1

2

3

4

2

1

3

1

2

Mount the MetroLinq onto the pole-mount bracket.

Tighten the four bolts to secure the MetroLinq.

Ensure the structure on which the unit is to be mounted is 

properly grounded and in compliance with ETSI ETS 300 253.

Verify that there is a good electrical connection to a 

grounding point (no paint or isolating surface treatment). 

Use the included (M4) screw to attach a grounding wire (not 

included) to the grounding point on the unit, and then to 

ground.

 

The earth connection must not be removed 

unless all supply connections have been disconnected.

Connect outdoor-rated Category 5e or better cable to the 
ETH PoE IN RJ-45 port. (The other end of this cable connects 

to the PoE power injector.)

Install a 10G SFP+ transceiver in the SFP+ port, and then 

connect fiber optic cabling to the transceiver. 
The following transceivers are supported:

◆

10GBASE-SR

◆

10GBASE-LR

3

4

1

2

1

2

2

1

1

2

ML-60-10G-360

E122017-CS-R01

ignitenet.com

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Cloud-Enabled Outdoor 60GHz PTMP + 5GHz + 2.4GHz

Model name(HVIN)

:

 

ML-60-10G-360