Quanta Computer Inc EY5 Benutzerhandbuch

This device has been tested to and conforms to the regulatory 

requirements of the European Union and has attained CE Marking. The 

CE Mark is a conformity marking consisting of the letters “CE”. The CE Mark 

applies to products regulated by certain European health, safety and environmental 

protection legislation. The CE Mark is obligatory for products it applies to: the 

manufacturer affixes the marking in order to be allowed to sell his product in the European 

market.

 

This product conforms to the essential requirements of the R&TTE directive 1999/5/EC in order to 

attain CE Marking.

 

The CE Marking is not a quality mark. Foremost, it refers to the safety rather than to the quality of a 

product. Secondly, CE Marking is mandatory for the product it applies to, whereas most quality markings 

are voluntary.

 

Marking: The product shall bear the CE mark

 

15.21

You are cautioned that changes or modifications not expressly approved by the part responsible for 

compliance could void the user’s authority to operate the equipment.

15.105(b)

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not installed and used 

in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not 

occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be 

determined by turning the equipment off and on, the 

user is encouraged to try to correct the 

interference by one or 

This Class B digital apparatus complies with Canadian ICES-003 

and RSS-247.

This device complies with Industry Canada license-exempt RSS standard(s). 

Operation is subject to the following two conditions:

(1) this device may not cause interference, and (2) this device must accept any 

interference, including interference that

may cause undesired operation of the device. Exposure of humans to RF fields (RSS-102)

The computers employ low gain integral antennas that do not emit RF field in excess of Health 

Canada limits for the general

population; consult Safety Code 6, obtainable from Health Canada's Web site at 

http://www.hc-sc.gc.-

ca/

The radiated energy from the antennas connected to the wireless adapters conforms to the IC limit of 

the RF exposure requirement

regarding IC RSS-102, Issue 5.

Cet appareil numérique de classe B est conforme à la norme NMB-003 et RSS-247.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio exempts 

de licence.L'exploitationest autorisée aux deux conditions suivantes:

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doitaccepter tout brouillage adioélectrique subi, même si le brouillage est 

susceptible d'en compromettre le fonctionnement.

Conformité des appareils de radiocommunication aux limites d'exposition humaine aux radiofréquences 

(CNR-102)

L'ordinateur utilise des antennes intégrales à faible gain qui n'émettent pas un champ électromag-

nétique supérieur aux normes

imposées par Santé Canada pour la population. Consultez le Code de sécurité 6 sur le site Internet 

de Santé Canada à

l'adresse suivante : 

http://www.hc-sc.gc.ca/

L'énergie émise par les antennes reliées aux cartes sans fil respecte la limite d'exposition 

aux radiofréquences telle que définie

par Industrie Canada dans ldu document CNR-102, version 5.

more of 

the following measures:

 

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to 

which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

 

1) this device may not cause harmful interference and

2) this device must accept any interference received, including interference that may cause 

undesired operation of the device.

 

This Transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter.

This device meets the government’s requirements for exposure to radio waves.

This device is designed and manufactured not to exceed the emission limits for exposure to radio 

frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.

The exposure standard for wireless device employs a unit of measurement known as the Specific 

Absorption Rate, or SAR.

CAUTION

 

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.

DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS

Please pair and connect your Pi-Solo with the APP for 

the correct date/time stamp.

写真を撮る前に、撮影時間を補正するためにAPPを接続します

Veuillez associer votre Pi-Solo à l'APP pour l'horodatage correct.

拍攝照片前，請先連接 APP 以校正拍照時間