Honeywell International Inc. THX9001R01 Benutzerhandbuch

Press and release CONNECT button.

Press and release the CONNECT button on the THM4000 Wireless Adapter. After a short delay, the CONNECTED status light will glow 
steady green..

MCR32943

Press and release the button on the bottom of the Internet 
Gateway. After a short delay, the RedLINK status light will glow 
steady green.

The Internet Gateway must be registered online before 
use at www.mytotalconnectcomfort.com. Enter the MAC 
ID and MAC CRC numbers located on the bottom of 
the Internet Gateway. For additional information, see 
instructions provided with the device.

MCR32942

WIRELESS SETUP

The linking procedure will time out if there is no keypress for 30 minutes. To begin again, 
press and hold in the lower right corner of the screen until the display changes (about 3 
seconds).

Press 

CONNECT on the Portable Comfort Control display screen. Press DONE when the 

screen displays "Connected." Press 

NO at the next screen to save and exit. (Or press 

YES to link another thermostat.)

E1 29 

Incompatible device cannot be connected.

E1 34 

Low RF signal. Move device to a different location and try again.

E1 38 

Make sure the thermostat is in Wireless Setup mode, 

 

and the Portable Comfort Control is at least 2 feet away (600 mm).

MCR33096

After a short delay, the status light will glow 
green for 15 seconds. If the status light 
turns red, the remote did not link with the 
thermostat for the connection process.