Honeywell International Inc. AZWDGL Benutzerhandbuch

 Installation and Operations Guide 

| 

Adding Alerton Wireless Temperature Sensors

 © Honeywell 

LTBT-TM-AZWIOG

Rev. 0001BETA

  

19

 

The Alerton Wireless Temperature Sensor (WTS) integrates with the AZW-5000 
to add programmable space temperature control without the expense of cutting 
walls and running wires. The WTS is available in two models: one with a 
temperature adjustment knob and manual override, and one without.

A WTS differs from other devices you might add to an AZW-5000 network 
because it does not need to be wired to a transceiver. It has an internal radio that 
acts as its transceiver. 

You can pair a WTS with an AZW-5000 transceiver or repeater, but not with a 
coordinator.



Set up the WTS using the WTS Installation Instructions 
(LTBT-TM-WTS-INST-USA).

Set the WTS DIP switches labeled S2 and S3 to match the ZigBee MAC 
address DIP switches on the associated AZW-5000.

WTS AVs and BVs

When a WTS device is connected to the network, the associated AZW-5000 
reads its AVs and returns the values shown.

Setpoint Adjust Range is set using AV-25 in the AZW-5000.

You can change the 

AZW-5000 points to which the values are written by setting 

these AZW-5000 AVs:

• AV-84 specifies where the temperature sensor reading is written

• AV-85 specifies where the temperature setpoint is written

• AV-86 specifies where the occupancy override status is written

• AV-87 specifies where the battery status is written

Temperature sensor reading

AV-80

AV-50

Temperature setpoint

AV-81

AV-51

Occupancy override status

AV-82

BV-52

Battery status

AV-83

BV-53