Murata Electronics North America 910M Benutzerhandbuch
WIT910
DIVISOR = (345600/RATE)-1
Round all non-integer values down. Note that the new data rate will take effect
immediately but will not be stored in non-volatile memory until the
immediately but will not be stored in non-volatile memory until the
m>
command is
issued. If an error is made in the baud rate setting toggling DTR or cycling power to the
WIT910 will cause the previous baud rate to be used.
WIT910 will cause the previous baud rate to be used.
Set Protocol Mode
Enables the base station to operate in a multipoint network. Depending on the user
application, more or less acknowledgment may be desired by the application. Remotes
can operate in transparent mode even though the base station is operating in one of the
nontransparent modes.
Enables the base station to operate in a multipoint network. Depending on the user
application, more or less acknowledgment may be desired by the application. Remotes
can operate in transparent mode even though the base station is operating in one of the
nontransparent modes.
When using a protocol mode, make sure to count in packet overhead when calculating
network performance. Refer to the section on Protocol Modes for details on each format.
network performance. Refer to the section on Protocol Modes for details on each format.
© 2000- 2004 Cirronet™ Inc
20
M-0910-0000 Rev -