Murata Electronics North America DNT900 Benutzerhandbuch
www.RFM.com
Technical support +1.800.704.6079
Page 3 of 58
©2008 by RF Monolithics, Inc.
E-mail: tech sup@rfm.com
DNT900 - 11/05/08
“To reduce potential radio interference to other users, the antenna type and its gain should be
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.”
“This device has been designed to operate with the antennas listed below, and having a
maximum gain of 6 dBi. Antennas not included in this list or having a gain greater than 6 dBi
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.”
so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication.”
“This device has been designed to operate with the antennas listed below, and having a
maximum gain of 6 dBi. Antennas not included in this list or having a gain greater than 6 dBi
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.”
Cushcraft S8963B 5 dBi gain dipole
Astron 918-2 6 dBi gain yagi
OEM Installation and Compliance Labeling
The DNT900 module is labeled with its own FCC ID number, and, if the FCC ID is not visible
when the module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed transmitter module.
This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: HSW-DNT900” or
“Contains FCC ID: HSW-DNT900”
Any similar wording that expresses the same meaning may be used. The Grantee may either
provide such a label, an example of which must be included in the application for equipment
authorization, or, must provide adequate instructions along with the module which explain this
requirement. In the latter case, a copy of these instructions must be included in the application for
equipment authorization.
The antenna connections from the module to the certain antennas approved with this device are not
unique and require Professional installation.
See section 3.8 of this manual for regulatory notices and labeling requirements. Changes or modifications
to a DNT900 not expressly approved by RFM may void the user’s authority to operate the module.
to a DNT900 not expressly approved by RFM may void the user’s authority to operate the module.