Murata Electronics North America DNT90E Benutzerhandbuch

Seite von 82
www.Murata.com
RF Product Department.
Technical support +1.678.684.2000
E-mail:
tech_sup@murata.com
Page 3 of 80
DNT90E Integration Guide - 04/13/16
Innovation, Science, and Economic Development (ISED) Canada Notice:
This device complies with ISED
Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR ISED Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
ISED RSS-247 Detachable Antenna Gain Restriction:
This radio transmitter (DNT90E), has been approved by ISED Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, or having a gain greater than the maximum gain indicated
for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (DNT90E ) a été approuvé par ISED Canada pour
fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal
et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette
liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour
l'exploitation de l'émetteur.
Antennas not included in this list or having a gain greater than 6 dB are strictly prohibited for use with
this device. The required antenna impedance is 50 ohms:
OMNI095 Omnidirectional Dipole Antenna, 5 dBi
YAGI099 Directional Antenna, 6 dBi
See Section 6.8 of this manual for regulatory notices and labeling requirements. Changes or modifica-
tions to a DNT90E not expressly approved by MURATA may void the user’s authority to operate the
module.