Murata Electronics North America HN2010 Benutzerhandbuch
HN-2010 Repeater
8
HopNet Family of Products
M-2410-0011, Rev -
Antenna and Power Connections
There are three external connections going into the repeater enclosure and one
internal connection:
• Two RF ports
• A 2-pin Conxall power connector
• An internal DB-9 connector
internal connection:
• Two RF ports
• A 2-pin Conxall power connector
• An internal DB-9 connector
RF Antenna Connectors
The two RF antenna connectors are standard female TNC. These ports connect to the
output of each internal modem. You can attach remote antenna cables to these
connectors.
output of each internal modem. You can attach remote antenna cables to these
connectors.
Conxall Power Connector
The Conxall power connector is waterproof and ruggedized for industrial use. This
connector supplies 9 VDC nominal operating power to the HN-2010 Repeater.
connector supplies 9 VDC nominal operating power to the HN-2010 Repeater.
DB-9 Connector
The DB-9 connector is located inside the back panel of the enclosure and is used to
configure the HN-2010. See the illustration below for the pin-out of the DB-9
connector.
configure the HN-2010. See the illustration below for the pin-out of the DB-9
connector.
9 Not Used
8 Clear to Send (CTS)
7 Request to Send (RTS)
6 Data Set Ready (DTR)
5 Ground
4 Not Used
3 Transmit Data (TX)
2 Receive Data (RX)
1 Data Carrier Detect (DCD)