Wacom DTU2235B Benutzerhandbuch
52
52
Interactive pen display
Double-clicking is difficult.
Be sure you are quickly tapping the display screen twice in the same
place on the pen display active area. Wacom recommends using the
side switch to double-click.
place on the pen display active area. Wacom recommends using the
side switch to double-click.
Open the Wacom Tablet control panel and go to the P
EN
tab.
Try increasing the T
IP
D
OUBLE
C
LICK
D
ISTANCE
or using a lighter T
IP
F
EEL
.
Windows: Try setting your system to launch programs with a single
click. See
click. See
The eraser selects everything
or will not stop erasing.
or will not stop erasing.
Open the Wacom Tablet control panel and go to the E
RASER
tab.
Move the E
RASER
F
EEL
slider toward F
IRM
, or select the D
ETAILS
...
button and increase the C
LICK
T
HRESHOLD
setting. If this does not help,
see
.
You notice a delay at the
beginning of pen or inking
strokes.
beginning of pen or inking
strokes.
Open the Wacom Tablet control panel and go to the P
EN
tab.
Try decreasing the T
IP
D
OUBLE
C
LICK
D
ISTANCE
. If that does not work,
move the T
IP
D
OUBLE
C
LICK
D
ISTANCE
slider to the O
FF
position in order
to turn off double-click assist.
You have to press hard with
the pen when clicking or
writing.
the pen when clicking or
writing.
Open the Wacom Tablet control panel and go to the P
EN
tab.
Move the T
IP
F
EEL
slider toward S
OFT
, or select the D
ETAILS
... button
and decrease the S
ENSITIVITY
and C
LICK
T
HRESHOLD
settings.
The pen tip does not function.
Be sure you are using the pen that originally came with your interactive
pen display. Other pens may not function properly on the pen display.
pen display. Other pens may not function properly on the pen display.
Check the control panel’s P
EN
tab and verify that a C
LICK
function is
assigned to the pen tip.
Make sure the status LED lights blue when the tip is pressed. If the
LED does not light, verify that the USB cable is plugged into an active
port on your computer or on a USB hub.
LED does not light, verify that the USB cable is plugged into an active
port on your computer or on a USB hub.
If the LED still does not light, you may have defective hardware (see
The pen tip and screen cursor
do not properly line up.
do not properly line up.
Open the Wacom Tablet control panel and select the C
ALIBRATE
tab.
Continue with
.
Changing the function settings
for the pen has no effect.
for the pen has no effect.
Make sure you change the settings for the pen and application that you
are using. See
are using. See