Proxim Wireless Corporation MP11R-ABG Benutzerhandbuch
MP.11-R Installation and Management
59
6
Configuration
This chapter describes configuring the unit’s settings using the unit’s Web Interface.
Click the Configure button to access configuration settings.
The following topics are discussed in this section:
•
System Parameters
•
Network Parameters
•
Interface Parameters
•
SNMP Parameters
•
RIP Parameters (Routing Mode Only)
•
Management Parameters
•
Security Parameters
•
Filtering Parameters
•
Intra-Cell Blocking (BSU Only; Bridge Mode Only)
•
VLAN Parameters (BSU Only; Bridge Mode Only)
•
QoS (Quality of Service) Parameters (BSU Only)
•
NAT (SU Only; Routing Mode Only)
Help and Exit buttons also appear on each page of the Web interface; click the Help button to access online help; click
the Exit button to exit the application.
the Exit button to exit the application.
For an introduction to the basics of management, see
Basic Management
.
System Parameters
The System configuration page lets you change the unit’s System Name, Location, Mode of Operation, and so on.
These details help you to distinguish the unit from other routers and let you know whom to contact in case you
experience problems.
These details help you to distinguish the unit from other routers and let you know whom to contact in case you
experience problems.
Click Configure > System; the following window is displayed.