Zebra Technologies Corporation MD-BTC2-E Benutzerhandbuch
QL 320 User’s Guide
11
2. Refer to Figure 5. Load the media
• Determine that the core diameter of the media roll matches
the setting of the Media Disks. If it does not, adjust the me-
dia disks per Figure 6 below.
dia disks per Figure 6 below.
• If the media support setting is correct, pull the media sup-
ports apart, insert the roll of media between them, and let
the media supports close. Insure that the media pulls off
the core in the direction
shown in Figure 5. The
supports will adjust
themselves to the
width of the media,
and the media
should be able to
spin freely on the
supports.
the media supports close. Insure that the media pulls off
the core in the direction
shown in Figure 5. The
supports will adjust
themselves to the
width of the media,
and the media
should be able to
spin freely on the
supports.
continued on next page
F
IGURE
5
Media Roll
Note direction
media pulls off
the roll.
media pulls off
the roll.
Media Disk
must match diame-
ter of Media Core.
ter of Media Core.
F
IGURE
6
Media Disk set for
3/4” core (factory
default).
3/4” core (factory
default).
Remove Media
Disk, rotate 180
Disk, rotate 180
∞
and replace for
1.40” core
1.40” core