Zebra Technologies Corporation MD-TRCV-24GHZ Benutzerhandbuch
2400 Wireless
2.4 GHz Transceiver
Part Number: CC15380-1
Features
The Zebra 2400 Wireless is a 2.4 Ghz radio
designed for OEM applications that oper-
ate in the unlicensed FCC band between
2.4-2.5 Ghz. The 2400 Wireless can be
used for communications where physical
connection is not desired. The following
objectives can be achieved with the 2400
Wireless, (i) provides a limited range radio
(20-30 feet line of sight), (ii) minimizes parts
count and associated cost, (iii) acts as a
cable replacement when used together with
Zebra Wireless printers. When combined
with Zebra’s Intelligent Wireless Controller
(part number CQ13867-1), the 2400 Wire-
less can be attached to any RS232C port.
To minimize integration headaches, the 2400
Wireless has modular FCC approval, which means that no additional FCC
approval is required by the OEM
designed for OEM applications that oper-
ate in the unlicensed FCC band between
2.4-2.5 Ghz. The 2400 Wireless can be
used for communications where physical
connection is not desired. The following
objectives can be achieved with the 2400
Wireless, (i) provides a limited range radio
(20-30 feet line of sight), (ii) minimizes parts
count and associated cost, (iii) acts as a
cable replacement when used together with
Zebra Wireless printers. When combined
with Zebra’s Intelligent Wireless Controller
(part number CQ13867-1), the 2400 Wire-
less can be attached to any RS232C port.
To minimize integration headaches, the 2400
Wireless has modular FCC approval, which means that no additional FCC
approval is required by the OEM
providing an approved antenna is used.
Note: The modular approval for this radio only applies for battery powered equipment.
Installation of this radio into A.C. connected equipment requires additional regulatory
approval. Please contact Zebra Technologies Corporation for details.
Installation of this radio into A.C. connected equipment requires additional regulatory
approval. Please contact Zebra Technologies Corporation for details.
Electrical
Input Voltage:
Vcc = 5 Volts +,-10%
Power Dissipation:
250 mW (receive mode)
350mW (transmit mode)
<5 mW (sleep mode)
350mW (transmit mode)
<5 mW (sleep mode)
Current Consumption:
50 mA (receive mode)
70 mA (transmit mode)
<1 mA (sleep mode)
70 mA (transmit mode)
<1 mA (sleep mode)
Operating Frequency:
2.482 GHz
Transmit Power Output:
-10 dBm (typical)
Receiver Sensitivity:
-85 dBm (typical)
Out of band interfering
signal rejection:
signal rejection:
60 dB (typical)
Baud rate:
user selectable
J1 Pin Assignments:
Pin #
Signal Name
1
Description
Pin 1
sleep/awake*
1 = sleep
Pin 2
Vcc
Pin 3
RXD
Receive Data
Pin 4
TX/RX*
1 = transmit
Pin 5
No connect
Pin 6
TXD
Transmit Data
Pin 7
GND
Pin 8
GND
J2
Pin Assignments:
Pin #
Signal Name
1
Description
(Optional)
Pin 1
GND
Pin 2
GND
J3
Pin Assignments:
Pin #
Signal Name
1
Description
(Optional)
Pin 1
GND
Pin 2
GND
Actual Size
1. All signals are at CMOS levels