Zebra Technologies Corporation RFID-R110PAX01 Benutzerhandbuch

Remove Used Ribbon

58981L-001 Rev. 1 9/7/2004

R110PAX3 User Guide

43

Open the media door.

Examine the ribbon. Did the ribbon run out?

Remove the empty core from the ribbon supply spindle. Save the core 
to use on the ribbon take-up spindle when you load ribbon.

Remove the used ribbon and core from the ribbon take-up spindle.

Install new ribbon following the instructions in 

.

Cut the ribbon near the ribbon take-up spindle.

Remove the used ribbon and core from the ribbon take-up spindle.

Locate an empty ribbon core. If necessary, remove and discard the 
used ribbon from the core removed in the previous step.

See 

. Install the empty ribbon core onto the 

ribbon take-up spindle, and push the core toward the print engine 
frame until it is fully seated.

Thread the remaining ribbon on the ribbon supply spindle following 
the instructions in 

.

See 

. Attach the end of the ribbon to the empty 

ribbon core with adhesive tape or a label, and wind for several turns 
in the direction shown. Ensure that the ribbon winds evenly on the 
spindle.