Zebra Technologies Corporation RFID-R110XI-03 Benutzerhandbuch

32

R110Xi/R170Xi User Guide

23063L-003 Rev. 2

12/17/04

Print a Printer Configuration Label

When you have loaded the media and ribbon (if necessary), print a configuration label as a 
record of your printer’s current settings. Keep the label to use when troubleshooting printing 
problems.

Connect the power cord to the power connection on the back of the printer.

To confirm the power connection, turn the printer On (I).

The printer performs the power-up self test (POST). When the test is complete, 

PRINTER 

READY

 displays on the front panel LCD.

Does the front panel LCD display 

PRINTER READY

?

Turn the printer Off (O).

Press and hold CANCEL while turning the printer On (I).

Release CANCEL when the DATA light turns off (approximately five seconds).

The configuration label prints (

Did the label print?

Caution • For personal and equipment safety, always use an approved three-conductor 
power cord specific to the region or country intended for installation. This cord must use 
an IEC 320 female connector and the appropriate region-specific three-conductor 
grounded plug configuration.

Continue with the next step.

Go to 

.

Printed

Connect the printer to your data source. Communication can be 
handled in many different ways. More information about the 
options is available in 

Did not print

Sensors out of position is a common cause of printing problems. 
Refer to 

. For additional 

assistance, refer to