JTS Professional Co Ltd R-4TB Benutzerhandbuch

FCC Statement

Notice: 

The changes or modifications not expressly approved by the party responsible for compliance 

could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE: 

To comply with the FCC RF exposure compliance requirements, no change to the antenna or 

the device is permitted. Any change to the antenna or the device could result in the device 

exceeding the RF exposure requirements and void user’s authority to operate the device.

FCC INFORMATION

The equipment has been tested and found to comply with the limits for a Class B 

Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation.  This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instruction, may cause harmful interference to radio 

communication. However, there is no grantee that interference will not occur in a particular 

installation. If this equipment dose cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on , the user is 

encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver 

is connected.

--Consult the dealer or an experienced radio/TV technician for help.

CONSUMER ALERT

This particular wireless microphone device operates in portions of the 617-652 MHz or 663-698

MHz frequencies. Beginning in 2017, these frequencies are being transitioned by the Federal

Communications Commission (FCC) to the 600 MHz service to meet increasing demand for

wireless broadband services. Users of this device must cease operating on these frequencies no

later than July 13, 2020. In addition, users of this device may be required to cease operations

earlier than that date if their operations could cause harmful interference to a 600 MHz service

licensee’s wireless operations on these frequencies. For more information, visit the FCC’s

wireless microphone website at www.fcc.gov/wireless-microphones-guide or call the FCC at 1-

888-CALL-FCC (TTY: 1-888-TELL-FCC).