MilDef Crete Inc. RK886EX Benutzerhandbuch

Seite von 60
Components and Functions 
 
 
16
Note: NEVER drop your HDD, FDD, CD-ROM module or expose them to high 
temperature, high humidity, or any hazardous environment.  NEVER try to 
disassemble the module.  
Static discharge may destroy your device and data. Always pick up the 
modules by touching the case only. 
CD-ROM Drive 
The CD-ROM drive is a standard IDE ATAPI type, which accepts a variety of 
standard 12cm CDs such as CD-ROM, audio CD, CD-I, Photo CD, video CD, 
etc. 
The following procedure assumes that all the necessary CD-ROM utilities were 
installed on the computer. For CD-ROM utility installation, please refer 
Utilities and Drivers”. 
Put CD into CD-ROM drive 
While the power is ON, push the CD-ROM drive's eject button.  The tray will 
release. Then gently pull the tray out. Put the CD on the holder and push the tray 
back into the cabinet. Any dirt on the data side of the CD may cause read error. 
Please do not touch this side when handling CDs. 
Read from CD-ROM drive 
The CD-ROM drive may be designated as drive D: or higher depending on your 
configuration. You may access it in DOS or Windows the same way you would 
for the floppy disk drive or hard disk drive. The CD-ROM is a read-only device. 
Any command attempting to write onto it will be denied. 
Please avoid shock or vibration while the CD-ROM drive is active.  
Express and PCMCIA Cards 
The computer supports one type-II PCMCIA and one Express card or two type-II 
PCMCIA cards. To remove the card, push the button on the right of the card to 
eject it. The eject button can hide into the compartment by pushing it inward 
gently. 
Dock under (optional) 
Dock under is utilized for system unit docking. The AC adapter or vehicle 
adapter attaches directly to Dock under and automatically charges the computer 
while docked.