Xmark Corporation XLX Benutzerhandbuch
Large Exciter Instructions
Part Number 805A6201
309 Legget Drive, Ottawa, ON K2K 3A3, Canada or
808 Commerce Park Drive, Ogdensburg, NY 13669 USA
808 Commerce Park Drive, Ogdensburg, NY 13669 USA
Telephone: 1-613-592-4642 Facsimile: 1-613-592-4296 Web Site: www.xmarksystems.com
© 2002 Instantel Inc. All Rights Reserved. Instantel and Hugs are registered trademarks of
Instantel Inc. in North America. The hearts logo and Xmark are trademarks of Instantel Inc. Xmark
is a division of Instantel Inc. Printed in Canada. November 2002. 805U6201 Rev B.
Instantel Inc. in North America. The hearts logo and Xmark are trademarks of Instantel Inc. Xmark
is a division of Instantel Inc. Printed in Canada. November 2002. 805U6201 Rev B.
Certifi ed to the ISO 9001 Quality Standard
Materials Required
• Exciter. Includes door contact, ferrite core (p/n 28A2029-0A2)
and terminal blocks.
• Facility fl oor plan indicating Exciter position and installation
orientation, and network wiring path.
• 105 Ω network terminator (p/n 805A2401) required to terminate
network. Two provided with each Controller (p/n 805A2201) or
Laptop Controller (p/n 805A2202).
Laptop Controller (p/n 805A2202).
• Suitable mounting hardware, such as wall anchors
• Optional: Passive infrared sensor for open doorways where door
contact cannot be used. Refer to Chapter 2 of the Hugs Instal-
lation Manual (p/n 805I0301) for important limitations on
using PIR sensors.
lation Manual (p/n 805I0301) for important limitations on
using PIR sensors.
Specifi cations
Read these instructions thoroughly
before installing the Exciter.
Faulty installation can lead to system failure.
before installing the Exciter.
Faulty installation can lead to system failure.
!
Installation Considerations
• Avoid metal—Do not install the Exciter behind or within 2
inches (50 mm) of metal objects, including metal doors. These
objects block the detection area of the Exciter.
objects block the detection area of the Exciter.
• Use door contacts—Door contacts are required to minimize
nuisance alarms.
• Confi gure nearby Exciters as slaves—Exciters installed within
30 feet (9 m) of each other must be confi gured as master and
slave. Up to four slaves may be connected to one master.
slave. Up to four slaves may be connected to one master.
• Use the supplied ferrite core—Wrap the power cable around the
supplied ferrite core, as explained in the instructions. Failure to
do so will void the user’s authority to operate the equipment.
do so will void the user’s authority to operate the equipment.
• Observe temperature and humidity restrictions—Refer to the
Specifi cations table.
• Leave slack in the cable—Leave at least 10 ft. (3 m) of slack in
the communication and power cable to allow for adjustments in
the location of the Exciter.
the location of the Exciter.
• No user adjustments to internal circuitry—Tampering may
cause component or system failure, or both, and will void the
warranty.
warranty.
Important Reference Documents
• Hugs Installation Manual (p/n 805I0301)
Refer to Chapter 2 of the Hugs Installation Manual for
detailed information on detection areas, installation options,
master/slave confi gurations and software settings.
detailed information on detection areas, installation options,
master/slave confi gurations and software settings.
• Hugs System Manual (p/n 805U1601)
• Exciter Tester Sheet (p/n 805U2101)
Materials Required
Specifi cations
Installation Considerations
Important Reference Documents
Have
you:
• Pulled network and
power cable?
• Resolved power supply
requirements?
• Selected Exciter orientation
and position?
If you answered, “No,” to any
of these questions, refer to
the Hugs Installation Manual
before installing.
of these questions, refer to
the Hugs Installation Manual
before installing.
Frequency
312.5 kHz
Supply
10-30 VDC
Current Draw
200 mA @ 24 VDC, 800 mA maximum
Relay Outputs (2)
30 VDC, 1 A, NO or NC
Detection radius
Adjustable, up to 11 ft.
Communications
LonWorks two-wire
Temperature - operating
32° to 122° F (0° to 50° C)
Temperature - storage
-40° to 176° F (-40° to 80° C)
Humidity
0 - 90% RH @ 70° F (21° C)
Dimensions
Approx 20.7 x 10.9 x 2.3 in. (526 x 275 x 60 mm)
Weight
Approximately 6 lbs. (2.7 kg)