HID Global Corporation 23X24X Benutzerhandbuch

 

 

 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 

 

PN: 2280-4587 

REV 4 

 

 

 

Card Reader kit consists of: 
 
1-Reader assembly 
1-Installation Kit 2270-0580 

1-Instructions 2280-4587

 
 
 

 
The Wall Mount Combination Proximity & Magnetic Stripe 
Card Reader reads the following format cards: 
 
Magnetic Stripe:  ABA/ANSI/ISO and EMPI 
Proximity:   HID 26-37 bit, EMPI and Proxi 10 

 

 
The readers are normally wall mounted and designed for 
indoor or outdoor use.  
 
Proximity cards are placed in front of the reader and normally 
read at a distance of six inches (at +5 VDC) and seven 
inches (at 12.0 VDC).  Mounting the readers on metal will 
typically reduce the distance. The data is transmitted to any 
host controller that can supply  +5 to +24 VDC operating 
voltage to the reader, and that can accept the standard 
Wiegand 26-bit or 34-bit format. 

 

 

Reade

 
1  The host controller must supply +5 to +24 VDC operating 

voltage to the reader.  The voltage drop as measured 
across the reader must be within 5 to 24.0 VDC. 

 
2  The maximum recommended reader distance from the 

host is: 

 

 

 

200 feet with #22 AWG 5 or 6-wire cable 

 

500 feet with #18 AWG 5 or 6-wire cable 

 
 

Unshielded wire is acceptable. Some host controllers may 
require tighter standards. 

 

 

1  The reader is designed to be mounted with the slot facing the 

floor. The user inserts the card upward into the card insertion 
slot. 

 
2  The reader can be mounted on a standard single-gang handy 

box, (the preferred method) or on any firm flat surface.  The 
mounting screws should be firmly tightened, but not 
excessively.  Note that the read head assembly screws are 
purposely loose to allow the head to "float"; no adjustments 
are necessary.  See figure 1. 

 
 

 

 
 

 

 

Figure 1

 

 

3  For outdoor applications, use a suitable weather-proof back 

box, or handy box, and install the weather seal (provided) on 
the back of the readers' base by pushing it securely and 
evenly into the "U" shaped recess. See figure 2. 

 

 

 
Grasp the lower edge of the reader cover. While applying gentle 
pressure pull the cover away from the base. 
 
4  Recommended reader mounting height from the floor is 

"shoulder height" or about 60 inches.  A lower height causes 
significant user inconvenience. Reader height may be 
lowered to accommodate ADA requirements. 

‰

‰