Trimble Inc. 10950 Benutzerhandbuch
40
Alloy GNSS reference receiver User Guide
14.
Press to edit the default gateway address.
15.
Press or to select the number to edit and then press or to change.
When finished, press .
Note – Editing starts from the right.
16.
Press to move to the next screen. The Home screen appears. Ethernet setup is now
complete.
Note – If you change the IP address, restart the receiver for the changes to take effect.
You can also use the keypad to configure the system setup or to view the satellite (SV) status
using the same process as outlined in this chapter.
using the same process as outlined in this chapter.
Setting up the receiver to log data
The Alloy receiver can be set up to log data using the front panel.
The receiver supports up to five independent sessions: Only the Default session parameters
can be configured using the front panel. The remaining four sessions can be activated from the
front panel but their configuration must be performed beforehand using the web interface.
1.
From the Home screen, press .
The Operation Mode screen appears.
2.
As reference station setup is the default, press repeatedly to move through the menu
choices until Logging is displayed.
The Logging screen allows you to edit the settings for the Default logging session.
3.
Do one of the following:
–
Press to edit the default session logging rate. Press or to select the
desired rate and then press .
–
Press to move to the logging rate field. Press to edit the logging rate.
Press to select a rate.
To store the new settings, press .
4.
Press to move to the next screen.
Enabling logging sessions
The Logging Session screen appears.
1.
Press to change the session to be enabled. Press or to move among the
session names. With the desired session name displayed, press to enable editing.