Trimble Inc. 6248192-B1 Benutzerhandbuch
8 Default Settings
66 SPSx80 Smart GPS Antenna User Guide
Default receiver settings
These settings are defined in the default application file.
Resetting the receiver to factory defaults
To reset the receiver to its factory defaults, do one of the following:
•
On the receiver, press
E
for 15 seconds.
•
In the GPS Configurator software, select
Connect to Receiver
and then click
Reset
receiver
in the General tab.
•
In the Configuration Toolbox software, select the General tab and then click
Reset Receiver
.
Note – For more information on the GPS Configurator and Configuration Toolbox software
which are supplied on the Trimble SPS GPS Receiver CD , see Chapter 6, Configuring the
Receiver Settings.
which are supplied on the Trimble SPS GPS Receiver CD , see Chapter 6, Configuring the
Receiver Settings.
Function
Factory default
SV Enable
All SVs enabled
General Controls:
Elevation mask
13°
PDOP mask
7
RTK positioning mode
Low Latency
Motion
Kinematic
Serial Port 1:
Baud rate
115,200
Format
8-None-1
Flow control
None
Serial Port 2:
Baud rate
115,200
Format
8-None-1
Flow control
None
Input Setup:
Station
Any
NMEA/ASCII (all supported messages)
All ports Off
Streamed output
All Types Off
Offset = 00
RT17/Binary
All ports Off
Reference position:
Latitude
0°
Longitude
0°
Altitude
0.00 m HAE
Antenna:
Type
Trimble SPS780, SPS880, Internal
Height (true vertical)
0.00 m
Group
All
Measurement method
Bottom of mount