Trimble Inc. 7112-900IP Benutzerhandbuch
12
2.1
TC900 Installation
The TC900 is pre-configured at the factory as a rover. No additional
configuration is necessary.
configuration is necessary.
To install a TC900 as a rover, follow these steps:
1.
Mount the provided o-ring and antenna tip (0dB or 3dB only) on the
flexible antenna base located on the top end-cap.
flexible antenna base located on the top end-cap.
2.
Use the recommended rover Power & I/O cable P/N 32942-17, see .
Attach the straight 8-pin female Bendix-Amphenol connector to the
TC900 and the angled connector to the rugged receiver.
Attach the straight 8-pin female Bendix-Amphenol connector to the
TC900 and the angled connector to the rugged receiver.
Figure 2-1
Power and I/O Cable (P/N 32942-17)
The TC900 rover works with a network of TRIMCOMM 900 repeaters.
Instructions for installation of the reference station and repeaters are
described in the TRIMCOMM 900 Operation Manual, P/N 33553-00.
Instructions for installation of the reference station and repeaters are
described in the TRIMCOMM 900 Operation Manual, P/N 33553-00.