Trimble Inc. 8262090 Benutzerhandbuch
SNRx10 Radio Modem User’s Guide 23
Configuration 3
3.3.2
Configuring a 900 MHz module using the one-way TC/LIP protocol
Note – 900 MHz modules used to communicate with the on-machine radios of a
GCS900 system should always be configured for two way communication. For this
reason, this section is not applicable to 900 MHz radios used as part of a Trimble
machine control network.
GCS900 system should always be configured for two way communication. For this
reason, this section is not applicable to 900 MHz radios used as part of a Trimble
machine control network.
To configure a 900 MHz module running the one way TC/LIP (Kea) protocol
complete the following steps:
complete the following steps:
1.
When a 900MHz Configuration dialog similar to the figure below appears,
select the network number.
select the network number.
2.
Click on Set. A progress bar appears. Once configuration has completed, click
on Menu ... to return to the Operations menu; otherwise, click on Exit to leave
WinFlash.
on Menu ... to return to the Operations menu; otherwise, click on Exit to leave
WinFlash.
3.3.3
Configuring a 900 MHz module using the IP protocol
To configure a 900 MHz module running the IP protocol complete the following
steps:
steps:
1.
When a Choose Mode of IP Operation dialog similar to the figure below
appears, select the operating mode.
appears, select the operating mode.
Available modes are as follows:
–
Traditional IP
–
Easy IP
Make sure Easy IP is selected.
DRAFT