Trimble Inc. 8262090 Benutzerhandbuch
5
Troubleshooting
4 2
SNRx10 Radio Modem User’s Guide
–
CMR Out or CMR xx% – the radio is transmitting CMRs. If CMR xx% is
shown, the percentage value must be greater than 90%.
shown, the percentage value must be greater than 90%.
–
Firmware <version and date> – firmware version and release data
–
Country Code <country code> – country code
4.
For SNB900 co-located bases, use the DOS command Ping to check the
integrity of the office computer and the machine by pinging the following
components:
integrity of the office computer and the machine by pinging the following
components:
–
the SNB900 access point
–
the SNRx10 on the machine
–
the computer on the machine
5.
For SNB900 co-located bases, connect to the SNB900 access point via your
office computer web bowser by entering the IP address of the SNB900 as the
destination web address. Check the following items:
office computer web bowser by entering the IP address of the SNB900 as the
destination web address. Check the following items:
–
LAN configuration on the Configure Ethernet page
–
connected device status on the Access Point Status page
6.
For SNB900 co-located bases, check the following configuration settings on
your office computer:
your office computer:
–
check the IP address of the office computer using the ipconfig /all DOS
command
command
–
check the routing to the on-machine radio using the TraceRt DOS
command
command
–
office computer firewall settings
7.
For SNB900 co-located bases, use the Configure operation of WinFlash to
check the following configuration settings:
check the following configuration settings:
–
Enabled options: the Access Point (AP) option must be enabled, and if the
Security option is enabled the option should either be turned off or
configured with a list of valid rover radio IP addresses
Security option is enabled the option should either be turned off or
configured with a list of valid rover radio IP addresses
–
The Easy IP configuration, particularly the Lemo Port and Modem Port
configuration
configuration
–
Advanced settings for proper naming of network devices
DRAFT