Trimble Inc. TC900C Benutzerhandbuch
3 Configuring the SNR900
1 0 SNR900 Operation Manual
3.1
Introduction
The SNR900 is a data modem and a radio in one unit. Two units can
provide a radio data link between Trimble GPS receivers.
provide a radio data link between Trimble GPS receivers.
3.2
Default Settings
The SNR900 serial ports are initially configured with the following
settings:
settings:
•
38400 baud
•
8 data bits, no parity
•
1 stop bit
The SNR900 is also initially configured as a rover; its network setting
is Network 1.
is Network 1.
When the SNR900 powers up, it retrieves its default settings from its
nonvolatile memory. The default settings can be changed whenever
necessary.
nonvolatile memory. The default settings can be changed whenever
necessary.
3.3
WinFlash Configuration Software
The Trimble WinFlash software is a Microsoft Windows-based
application that configures the SNR900 for use in a network. Use
WinFlash to configure all SNR900 radios required for a project.
application that configures the SNR900 for use in a network. Use
WinFlash to configure all SNR900 radios required for a project.
Note – The Trimble CommSet software is required to configure
Trimble SiteNet 900 radios.
Trimble SiteNet 900 radios.
To configure a SNR900 using WinFlash, complete the following
procedures:
procedures:
1.
Connect the office computer to the SNR900.
2.
Configure the SNR900 using WinFlash.
These procedures are discussed in the following sections.
SNR900.book Page 10 Friday, December 3, 2004 2:02 PM