Hughes Network Systems 24SX-001 Benutzerhandbuch
1027144– 0001 Revision D
6–22 Installing ODUs
RT installation
3.
Rotate the transceiver, making sure the transceiver’s
mounting bolts slide into the grooves in the antenna flange.
(The direction of rotation depends on the orientation of the
antenna bracket—to the right or left.) If the mounting bolts
will not slide into the grooves, loosen the bolts. See figure
6-22.
mounting bolts slide into the grooves in the antenna flange.
(The direction of rotation depends on the orientation of the
antenna bracket—to the right or left.) If the mounting bolts
will not slide into the grooves, loosen the bolts. See figure
6-22.
T0009011
Boresight
Mounting bolts must be
fully inserted in flange
grooves.
Rotate transceiver to slide bolts into grooves.
(Rotation direction depends on orientation
of antenna bracket to right or left.)
of antenna bracket to right or left.)
Figure 6-22
Rotating the mounting bolts into the grooves
4.
Fully tighten the transceiver mounting bolts.
5.
After tightening the transceiver, look through the boresight
to make sure the antenna is still pointed at the HT.
to make sure the antenna is still pointed at the HT.
The ODU is now installed, but still needs to be grounded,
connected to the IFL, and electronically pointed.
connected to the IFL, and electronically pointed.