Wi Lan Inc EB03 Benutzerhandbuch
1 Obtain Network Plan
JUL 2001 Rev 03
13
1 Obtain Network Plan
The network plan describes the network in detail, including the following.
• Type and number of units
• Physical layout
• Configuration settings for each unit
• Site names, IP addresses and links
• Antenna types, RF cables and cable lengths, surge suppressors, terminators
• Network cable types and lengths
• Grounding kits and backup power requirements
• Link budget
• Floor plans and equipment cabinet requirements
The network plan should be completed before any equipment is installed in the field. See
, page 113 for more information about network planning.
2 Assemble Units
➧
To assemble a unit and check the power
1.
Connect the indoor antenna to the Antenna port at the back of the unit.
Note: Indoor antenna may be different from the illustration.
CAUTION
Never operate a unit without an antenna, dummy load, or terminator
connected to the antenna port.
Operating a unit without an antenna, dummy load, or terminator connected
to the antenna port can permanently damage a unit.
! Important
The AWE 120-24 must be connected only to a Wi-LAN approved power
supply unit with an output of 12 Vdc. See
pinout information.