Wi Lan Inc EB03 Benutzerhandbuch
Configuration
52
AWE 120-24 Installation & Configuration Guide
Performing Link Monitor Test (Normal Mode)
The link monitor test can be run from either a base station or a remote unit that is set to Normal Mode. The
test operates in parallel with the message stream, so it consumes some of the link’s total data capacity. You
can control the ratio of test data to message data (and thereby control the amount of test data overhead) by
setting the link monitor period. See
test operates in parallel with the message stream, so it consumes some of the link’s total data capacity. You
can control the ratio of test data to message data (and thereby control the amount of test data overhead) by
setting the link monitor period. See
for more information.
Note: Link monitor test stays in effect even if you power cycle or reboot units, so you must turn it off using
the Link Monitor Period (0 = OFF) setting.
➧
To perform Link Monitor test from a base station
1.
Connect the test PC to the Serial port of the base station. See
2.
Log in to the unit and go to the Main Menu.
3.
Select RF Station Configuration and press
Enter
. The RF Station Configuration menu is
displayed.
4.
Select Operating Mode and press
Enter
. The data field highlights.
5.
Press the arrow keys to select Normal mode and press
Enter
.
6.
Select RF Transmit Status and press
Enter
. The data field highlights.
7.
Press the arrow keys to select unblocked and press
Enter
.
8.
Select Link Monitor Remote Station Rank and press
Enter.
The data field highlights.
9.
Type the rank of the remote unit that you want to link to and press
Enter
. (The rank is the identification
number of the remote unit. The rank of a remote can be any number from 1 – 1000. See
10. Select Link Monitor/Output Power and press
Enter
. Set it to Normal.
RF Station Configuration
Operating Mode -> Normal Mode
RF Transmit Status unblocked
Link Monitor Period (0=OFF, 1-10000) 0
Test Mode Timer Minutes (1-1000) 5
Base Station Only Parameters
Maximum Remote Distance 5 Km
Link Monitor Remote Station Rank 1
Remote Station Only Parameters
Throttle Enable off
Throttle Level (1-100) 10 (640 kps)
Link Monitor/Output Power Normal
User Output Power Adjust Ceiling -5 dB
Signal Margin (6-31) dB 6
Current Output Power Level Adjust -21