Titan Electronics Inc NETCOM423 Benutzerhandbuch

name of course requires a DNS server, see at 5.1.1.2 Server Parameter 
above. 
Below these options there is the button “Save”. This will store all 
configurations done here in the NetCom. In many cases NetCom 
requires a reboot to proceed. 

This is also a huge menu. Each serial port of the NetCom is listed in a 
separate Column. The top half of the parameters titled “Serial Settings” 
is directly related to common serial configurations. The bottom half 
titled “Transfer Settings” configures the operation mode of NetCom on 
the network. Each serial port is configured separately, there is no setting 
shared between ports. 
5.1.2.1. Serial 

The NetCom devices allow to operate in 
RS422/485 modes. This is configured by 
the Master DIP switches or by software, 
“PortType (current)” displays the current 
setting. If the DIP switches are set for 
«

Selected by Software»

, the mode 

of operation is chosen by the “PortType” 
parameter. 

 

Image 26: Web Panel Serial Settings 

 

Image 27: Web Panel Op-Mode by Software 

The serial port is based on enhanced 
UARTs, the type and maximum speed 
are also displayed. 

When the NetCom is used via the Virtual Com Driver mode, the serial 
parameters are controlled by the application, which opened the serial 
port. However certain installations use a different operation without 
Driver mode. Then the serial parameters must be defined separately. 
This is done in this panel. 

823RM WLAN, 1623RM WLAN  

Page 

32