Itron Inc. 80WI Benutzerhandbuch
Chapter 2 Installing the 80W-i
8 Proprietary and Confidential
TDC-0830-002 80W-i Endpoint Installation Guide
2. Push the antenna coupler into the 80W-i antenna slot until the coupler end (1) reaches
the bottom edge of the 80W-i. The antenna coupler notch will rest on the antenna
coupler bracket (2).
coupler bracket (2).
Remote antenna installation is complete.
Installing in a New Lid
This section describes installation of the 80W-i endpoint in a pit lid without a drilled hole.
Required Tools and Hardware
• Drill
• 1 3/4-inch drill bit appropriate for the lid material
• 1 3/4-inch drill bit appropriate for the lid material
Note The Remote Antenna is not intended for applications involving
vehicular traffic. Use the Remote Antenna in incidental traffic areas (such
as residential environments).
vehicular traffic. Use the Remote Antenna in incidental traffic areas (such
as residential environments).
To install the remote antenna in new pit lids
1. Select a hole location with enough clearance on the bottom side of the lid to attach the
retainer clip collar and cable ties or threaded clip collar.
2. Drill a 1 3/4 inch hole in the lid.
page 6.