Itron Inc. OW3 Benutzerhandbuch

Note: The password for every CGR is different. The password does not appear on the
screen as you enter it.

3. Type show module.
4. Confirm that the Itron CAM module location is shown (for example, CGR1000 Third

Party Module). In the example above, Mod 4 is Slot #4. Under Status, ok indicates
that the device is powered and active.

Powering Down the CAM

Note: In the example described here, the CAM is located in Slot #4. If your CAM is located
in Slot #5, the same procedure applies. In this case, use Slot #5.

1. Type conf t (configuration terminal). The prompt changes to (config).
2. Type hw power 4 (in this example, the CAM is located in Slot #4).
3. Type do show module.
4. If successful, the Status indicates powered-dn (powered down).

Note:

• If it is not showing powered down, verify that (config) shows in the prompt. If not,

re-enter conf t.

• Once (config) is shown in the prompt, issue the hw power 4 command a second

time.

• Verify that the Status is powered-dn with another do show module command.

Verifying the CAM Location

After the CAM is powered down, use the following procedure to check the hardware

components.
Note: In the example described here, the CAM is located in Slot #4. If your CAM is located
in Slot #5, the same procedure applies. In this case, use Slot #5.

Field Replacement

OpenWay® Riva CAM3 Installation Guide

51