Acumen Technologies Ltd EON0304 Benutzerhandbuch
2 seconds button function will be temporarily restored, “*Child-Proof*” will disappear
from the LCD.
from the LCD.
4. If no button is pressed within 2 minutes, the Remote Transmitter will return to
Child-Proof function and “*Child-Proof*” will reappear on the LCD until the
Child-Proof switch is slide back to the other position.
Child-Proof switch is slide back to the other position.
1.0.6. Settings
1. Press and hold clock button for about 2 seconds.
2. The hour display will flash. Use the Up and Down buttons to set the hour.
3. Pres the clock button again and the minute display will flash. Use the Up and Down buttons
2. The hour display will flash. Use the Up and Down buttons to set the hour.
3. Pres the clock button again and the minute display will flash. Use the Up and Down buttons
to set the minutes.
4. Press the clock button again and the
°F or °C display will flash. Use the Up and Down
button to select the Remote Transmitter to display temperature in
°F or °C.
5. Press the clock button again to exit setting.
1.0.7. Batteries
1. The Remote Transmitter uses 3 AAA-size batteries. Replace these batteries at least every
6 months or when the Low battery indicator on the LCD is on.
2. After you take out the batteries, wait for at least 1 minute before putting fresh
batteries into the Remote Transmitter.
3.
Use fresh alkaline batteries only.
1.0.8. Transmitter Location Function
Acumen’s Remove Control’s location function can help user to find the Remove Transmitter
easily. Turn on the Transmitter Location function by pressing the “Tx Locator” button on
the Remove Receiver, and then transmitter will beep continuously (Two short and one long
beep), Press any button on the Remove Transmitter to turn it off.
1.0.9. Receiver Low Battery Warning
Low Battery Indicator on the Remove Receiver automatically measures low battery power from
the Remove Receiver. When the battery runs low and needs to be replaced, the indicator will
blink in red and the LCD of the transmitter will display. Replace the batteries as soon
as practical.
2.0 IMPORTANT SAFETY FEATURE
You can set a private code into your system to prevent accidental operation by another
transmitter nearby.
transmitter nearby.
2.1 Coding Instructions
1. Remove the cover on the back of the Remote Transmitter to expose the code switches. Slide
the code switches to you choice of ON or OFF positions. FACTORY SETTING IS ALL ”OFF”.
2. Remove power from the Remote Receiver by unplugging the power cord or power off at the
circuit breaker.
3. Take the Remote Transmitter close to the fireplace or the Remote Receiver (less than
2-10 foot from the fireplace or Remote Receiver is recommended.)
4. Powering-up the Remote Receiver.
5. Install fresh AAA alkaline batteries into the Remote Transmitter.
6. Press a button on the Remote Transmitter. The Remote Receiver will produce a ‘beep’
5. Install fresh AAA alkaline batteries into the Remote Transmitter.
6. Press a button on the Remote Transmitter. The Remote Receiver will produce a ‘beep’
sound when it receives the code from the Remote Transmitter.
7. If you do not hear a ‘beep’ sound from the Remote Receiver, removes batteries from
the Remote Transmitter and power from the Remote Receiver. Wait for 1 minute and repeat
step 3 to 6.
step 3 to 6.
8.
The system is now ready to operate.
Note: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.