VTech Telecommunications Ltd 80-0585-00 Benutzerhandbuch

Seite von 2
Industry Canada
Operation is subject to the following two conditions: (1) this device may not 
cause harmful interference, and (2) this device must accept any interference, 
including interference that may cause undesired operation of the device.
Privacy of communications may not be ensured when using this telephone.
The term ‘’IC:‘’ before the certification/registration number only signifies that 
the Industry Canada technical specifications were met.
This product meets the applicable Innovation, Science and Economic 
Development Canada technical specifications.
For C-ETL compliance only
Mesures de sécurité importantes
Vous devez toujours observer des mesures de précaution lorsque vous 
utilisez le Téléphone de conférence avec microphones sans fil ErisStation, 
afin d’éviter les risques d’incendie, d’électrocution et de blessures, incluant 
ce qui suit :  
1.  Lisez et comprenez bien toutes les instructions.
2.  Observez toutes les instructions et mises en garde inscrites sur 
l’appareil.
3.  Débranchez ce téléphone de la prise murale avant de le nettoyer. 
N’utilisez pas de nettoyeurs liquides ni en aérosol. N’utilisez qu’un 
chiffon doux et légèrement humecté.
4.  N’utilisez pas ce produit près de l’eau, tel que près d’un bain, d’un 
lavabo, d’un évier de cuisine, d’un bac de lavage ou d’une piscine, ou 
dans un sous-sol humide ou sous la douche.
5.  Ne déposez pas ce téléphone sur un chariot, support ou table 
chancelants. L’appareil pourrait tomber   et être sérieusement 
endommagé.
6.  Les ouvertures situées à l’arrière ou sous le socle et le microphone sans 
fil servent à la ventilation. Afin d’empêcher la surchauffe, ces ouvertures 
ne doivent pas être obstruées en plaçant l’appareil sur un lit, divan, tapis 
ou autre surface similaires. Ne placez pas cet appareil à proximité d’un 
élément de chauffage ni d’une plinthe électrique. De plus, ne l’installez 
pas dans une unité murale ou un cabinet fermé qui ne possède pas 
d’aération adéquate.
7.  Ne faites fonctionner cet appareil qu’avec le type d’alimentation indiqué sur 
les étiquettes de l’appareil. Si vous ne connaissez pas le voltage de votre 
maison, consultez votre marchand ou votre fournisseur d’électricité.
8.  Ne déposez rien sur le cordon d’alimentation. Installez cet appareil dans 
un endroit sécuritaire, là où personne ne pourra trébucher sur la ligne 
d’alimentation ni le cordon téléphonique modulaire.
9.  N’enfoncez jamais d’objets dans les fentes du socle ou du microphone 
sans fil, car ceci risquerait d’entrer en contact avec des points de 
tension dangereux ou provoquer un court-circuit. N’échappez pas de 
liquides dans l’appareil.
10.  Afin de réduire les risques d’électrocution, ne démontez pas l’appareil, 
mais apportez-le plutôt à un centre de service qualifié s’il doit être réparé. 
L’ouverture ou le retrait de pièces du socle ou du microphone sans fil autre 
que les portes d’accès peuvent vous exposer à des tensions dangereuses 
et à d’autres risques. Débranchez l’appareil avant de procéder au 
nettoyage. Utilisez un chiffon humide et doux.
11.  Ne surchargez pas les prises de courant et les rallonges.
12.  Débranchez cet appareil de la prise de courant et communiquez avec le 
département de service à la clientèle de VTech dans les cas suivants :
• 
Lorsque le cordon d’alimentation est endommagé ou écorché.
• 
Si du liquide a été échappé dans l’appareil.
• 
Si l’appareil a été exposé à une source d’humidité telle que la pluie 
ou l’eau.
• 
Si le produit ne fonctionne pas normalement en respectant les 
instructions de fonctionnement.  Réglez uniquement les com-
mandes indiquées dans le les instructions de fonctionnement. Les 
réglages incorrects des autres commandes pourraient provoquer 
un dommage qui pourrait exiger un travail exhaustif de la part d’un 
technicien autorisé afin de rétablir le fonctionnement normal de 
l’appareil.
• 
Si le produit a été échappé et que le socle et/ou le microphone sans 
fil a été endommagé.
• 
Si le produit affiche une nette diminution de sa performance.
13.  Évitez d’utiliser le Téléphone de conférence avec microphones sans fil 
ErisStation pendant un orage.
14.  N’utilisez pas le Téléphone de conférence avec microphones sans 
fil ErisStation pour rapporter une fuite de gaz à proximité de la fuite. 
En certaines circonstances, une flammèche pourrait être provoquée 
lorsque l’adaptateur est branché dans une prise de courant ou lorsque 
le microphone auxiliaire est déposé sur son socle. Ceci est un événe-
ment commun associé à la fermeture d’un circuit électrique. L’utilisateur 
ne doit pas brancher le téléphone dans une prise de courant ni insérer 
un microphone sans fil rechargé dans le socle, si le téléphone se trouve 
dans un environnement contenant des concentrations de matières 
inflammables ou autres gaz susceptibles de produire des flammes, 
sauf en présence d’une aération adéquate. Une flammèche dans un 
tel endroit pourrait provoquer un incendie ou une explosion. De tels 
environnements peuvent comprendre: des endroits où l’on utilise de 
l’oxygène médical sans ventilation adéquate; des gaz industriels (dis-
solvants de nettoyage, des vapeurs d’essence, etc.); une fuite de gaz 
naturel, etc.
15.  Ces adaptateurs ont été conçus pour être orientés en position verticale 
ou montés au sol. Les broches ne sont pas conçues pour maintenir 
l’adaptateur en place si celui-ci est barnché dans une prise au plafond 
ou sous une table/ armoire.
16.  Pour les PRODUITS À BRANCHER À UNE PRISE DE COURANT, la 
prise de courant doit être installée près du produit, afin d’assurer une 
accessibilité sécuritaire à la prise de courant.
17.  MISE EN GARDE : Il peut y avoir un risque d’explosion si vous utilisez 
le mauvais type de piles. N’utilisez que le bloc-piles rechargeable inclus 
ou le bloc-piles de rechange (GP230AAHC6YMXZ). N’incinérez pas les 
piles. Celles-ci risqueraient d’exploser. Jetez les piles usées selon les 
renseignements suivant 
le sceau du RBRC
MD
.
18.  N’utilisez que les adaptateurs inclus avec ce produit. L’utilisation d’un 
adaptateur dont la polarité ou la tension serait inadéquate risque 
d’endommager sérieusement le produit et mettre votre sécurité en péril.
Adaptateur : Entrée 100–240V CA 50/60 Hz; Sortie : 12V DC @ 1.0A.
CONSERVEZ CES INSTRUCTIONS
Introduction
Important safety instructions
When using your ErisStation SIP DECT Expansion Wireless Speakerphone, 
basic safety precautions should always be followed to reduce the risk of fire, 
electric shock and injury to persons, including the following:
1.  Read and understand all instructions.
2.  Follow all warnings and instructions marked on the product.
3.  Unplug this product from the wall outlet before cleaning. Do not use 
liquid or aerosol cleaners. Use a damp cloth for cleaning.
4.  Do not use this product near water such as near a bathtub, wash bowl, 
kitchen sink, laundry tub or swimming pool, or in a wet basement or 
shower.
5.  Do not place this product on an unstable table, shelf, stand or other 
unstable surfaces.
6.  Slots and openings in the back or bottom of the base unit and wireless 
mic are provided for ventilation. To protect them from overheating, these 
openings must not be blocked by placing the product on a soft surface 
such as a bed, sofa or rug. This product should never be placed near or 
over a radiator or heat register. This product should not be placed in any 
area where proper ventilation is not provided.
7.  This product should be operated only from the type of power source 
indicated on the marking label. If you are not sure of the type of power 
supply in your office, consult your dealer or local power company.
8.  Do not allow anything to rest on the power cord. Do not install this 
product where the cord may be walked on.
9.  Never push objects of any kind into this product through the slots in the 
base unit or wireless mic because they may touch dangerous voltage 
points or create a short circuit. Never spill liquid of any kind on the product.
10.  To reduce the risk of electric shock, do not disassemble this product, but 
take it to an authorized service facility. Opening or removing parts of the 
base unit or wireless mic other than specified access doors may expose 
you to dangerous voltages or other risks. Incorrect reassembling can 
cause electric shock when the product is subsequently used. 
11.  Do not overload wall outlets and extension cords.
12.  Unplug this product from the wall outlet and refer servicing to an 
authorized service facility under the following conditions: 
• 
When the power supply cord or plug is damaged or frayed.
• 
If liquid has been spilled onto the product.
• 
If the product has been exposed to rain or water.
• 
If the product does not operate normally by following the operat-
ing instructions. Adjust only those controls that are covered by the 
operation instructions. Improper adjustment of other controls may 
result in damage and often requires extensive work by an autho-
rized technician to restore the product to normal operation.
• 
If the product has been dropped and the base unit and/or wireless 
mic has been damaged.
• 
If the product exhibits a distinct change in performance.
13.  Avoid using the ErisStation SIP DECT Expansion Wireless Speakerphone 
during an electrical storm. There is a remote risk of electric shock from 
lightning.
14.  Do not use the ErisStation SIP DECT Expansion Wireless Speakerphone to 
report a gas leak in the vicinity of the leak. Under certain circumstances, a 
spark may be created when the adapter is plugged into the power outlet. 
This is a common event associated with the closing of any electrical cir-
cuit. The user should not plug the phone into a power outlet if the phone 
is located in an environment containing concentrations of flammable or 
flame-supporting gases, unless there is adequate ventilation. A spark in 
such an environment could create a fire or explosion. Such environments 
might include: medical use of oxygen without adequate ventilation; in-
dustrial gases (cleaning solvents; gasoline vapors; etc.); a leak of natural 
gas; etc. 
15.  The power cables are intended to be correctly oriented in a vertical or 
floor mount position. The prongs are not designed to hold the plug in 
place if it is plugged into a ceiling or cabinet outlet.
16.  For pluggable equipment, the socket-outlet shall be installed near the 
equipment and shall be easily accessible.
17.  CAUTION: Use only the batteries indicated in this manual. There may 
be a risk of explosion if a wrong type of battery is used. Use only the 
supplied rechargeable battery or replacement battery pack (GP230AAH-
C6YMXZ). Do not dispose of batteries in a fire. They may explode. 
Dispose of used battery according to the information in 
The RBRC
®
 seal.
18.  Use only the adapter included with this product. Incorrect adapter 
polarity or voltage can seriously damage the product. Base unit power 
adapter: Input 100–240V AC 50/60Hz; Output: 12V DC @ 1.0A.
SAVE THESE INSTRUCTIONS
FCC, ACTA and IC regulations
FCC Part 15
This equipment has been tested and found to comply with the requirements 
for a Class B digital device under Part 15 of the Federal Communications 
Commission (FCC) rules. These requirements are intended to provide 
reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can 
be determined by turning the equipment off and on, the user is encouraged 
to try to correct the interference by one or more of the following measures: 
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the 
party responsible for compliance could void the user’s authority to operate 
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to 
the following two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including 
interference that may cause undesired operation. Privacy of communications 
may not be ensured when using this telephone.
To ensure safety of users, the FCC has established criteria for the amount of 
radio frequency energy that can be safely absorbed by a user or bystander 
according to the intended usage of the product. This product has been tested 
and found to comply with the FCC criteria. The wireless mic may be safely 
held against the ear of the user. The telephone base shall be installed and 
used such that parts of the user’s body other than the hands are maintained 
at a distance of approximately 20 cm (8 inches) or more.
This Class B digital apparatus complies with Canadian requirement CAN 
ICES-3 (B)/NMB-003(B)
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du 
Canada.
Safety 
Information 
and Warranty
Model: VCS850
Wireless Conference System
ErisStation
TM
businessphones.vtech.com
SIP DECT Expansion Wireless Speakerphone
ErisStation
®
 is a registered trademark of VTech Communications, Inc.  
Orbitlink Wireless Technology
TM
 is a trademark of VTech Communications, Inc.
®