VTech Telecommunications Ltd 80-5316-00 Benutzerhandbuch

Seite von 1
FCC, ACTA and IC Regulations 
 
• In to event shall VTech be liable for any indirect, special, incidental, consequential, or similar damages (including, 
but not limited to lost profits or revenue, inability to use the product, or other associated equipment, the cost of 
substitute equipment, and claims by third parties) resulting from the use of this product, some states do 
not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may 
not apply to you. 
 
FCC, ACTA and IC Regulations 
This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States. 
It also complies with regulations RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the 
following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, 
including interference that may cause undesired operation of the device. 
 
A label is located on the underside of the Base Unit containing either the FCC registration number and Ringer 
Equivalence Number (REN) or the IC registration number and Load Number. You must, upon request, provide this 
information to your local telephone company. 
 
This equipment is compatible with inductively coupled hearing aids. Should you experience trouble with this telephone 
equipment, please contact: 
 
VTech Communications Inc 
CUSTOMER SERVICE at 1-800-595-9511. In Canada, call VTech Telecommunications Canada Ltd. at 1-800-267-
7377. 
 
For repair/warranty information. The telephone company may ask you to disconnect this equipment from the line 
network until the problem has been corrected. 
 
FCC Part 15 
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.  
 
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try and correct the interference by one or more of the following measures: 
• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment and receiver. 
• Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected. 
• Consult the dealer or an experienced radio/TV technician for help. 
 
To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be 
safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested 
and found to comply with the FCC criteria. The handset has such a low power that it does not require testing. It may 
be safely held against the ear of the user. The base unit shall be installed & used such that parts of the user’s body 
other than the hands should be maintained at a comfortable distance of approximately 20 cm or more. 
 
FCC and ACTA Information 
If this equipment was approved for connection to the telephone network prior to July 23, 2001, it complies with Part 68 
of the Federal Communications Commission (FCC) rules. If the equipment was approved after that date, it complies 
with the Part 68 rules and with Technical Requirements for Connection of Equipment to the Telephone Network 
adopted by the Administrative Council for Terminal Attachments (ACTA). We are required to provide you with the 
following information. 
1. Product identifier and REN information 
The label on the back or bottom of this equipment contains, among other things, an identifier indicating product 
approval and the Ringer Equivalence Number (REN). This information must be provided to your local telephone 
company upon request. For equipment approved prior to July 23, 2001, the product identifier is preceded by 
the phrase “FCC Reg No.” and the REN is listed separately. For equipment approved after that date, the product