VTech Telecommunications Ltd 80-6761-00 Benutzerhandbuch

Seite von 66
4
Getting started
When the screen shows LOW BATTERY, the backlight is off.
If the handset will not be used for a long time, disconnect and remove the 
battery to prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.
com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or 
call 1 (800) 267-7377.
Battery installation and charging
Install the battery as shown below. After installing the battery, you might 
be able to make and receive short calls. For best performance, charge the 
handset for at least 16 hours before use. When not in use, place the handset 
in the telephone base or charger. See page 45 for battery operating times.
Battery indicators
Battery status
Action
The screen is blank.
Battery has no charge 
and the handset cannot 
be used.
Charge until the screen shows 
LOW BATTERY (at least 10 
minutes).
The screen shows 
PLACE IN CHARGER 
and 
ƀCUJGU
Battery has very little 
charge and the handset 
cannot be used.
Charge until the screen shows 
LOW BATTERY (about four 
minutes).
The screen shows 
LOW BATTERY,
ƀCUJGUCPFVJG
handset beeps.
Battery has enough 
charge to be used for a 
short time.
Charge until the screen shows 
HANDSET X (about one hour).
The screen shows 
HANDSET X.
Battery is charged.
To keep the battery charged, 
place it in the telephone base 
or charger when not in use.
If the battery compartment cover is on the handset, press the indentation 
and slide the cover to remove.
Plug the battery connector securely into the socket inside the handset 
battery compartment, matching the color-coded label.
Place the battery with the label THIS SIDE UP facing up and the wires 
inside the battery compartment.
#NKIPVJGEQXGTƀCVCICKPUVVJGDCVVGT[EQORCTVOGPVVJGPUNKFGKVVQYCTFU
the center of the handset until it clicks into place.
Charge the handset by placing it in the telephone base or charger. The 
CHARGE light is on when the handset charges.
1.
2.
3.
4.
5.
1
3
2
4
5
Charge light