VTech Telecommunications Ltd 80-7264-01 Benutzerhandbuch

5

Once you have installed the battery, the screen indicates the battery status 
(see the table below). If necessary, place the handset in the telephone base 
or charger to charge the battery. For best performance, keep the handset in 
the telephone base or charger when not in use. The battery is fully charged 
after 16 hours of continuous charging. See the table on page 74 for battery 
operating times.
If the screen is blank, you need to charge the handset without interruption for 
at least 10 minutes to give the handset enough charge to use the telephone 
for a short time. When the battery is low, the handset beeps and shows 
Low battery

CPFCƀCUJKPI . If you are on a call in low battery mode, the 

handset beeps every minute.
The following table summarizes the battery charge indicators and actions 
to take.

Battery indicators

Battery status

Action

The screen is blank.

Battery has no charge 
and the handset cannot 
be used.

Charge without interruption 
until the screen shows 
HANDSET X (at least 
10 minutes).

The screen shows 
Place in charger and 

ƀCUJGU

Battery has very little 
charge and the handset 
cannot be used.

Charge without interruption 
until the screen shows 
HANDSET X (at least 
four minutes).

The screen shows 
Low battery,

ƀCUJGUCPFVJG

handset beeps.

Battery has enough 
charge to be used for a 
short time.

Charge without interruption 
until the screen shows 
HANDSET X (at least 
30 minutes).

The screen shows 
HANDSET X.

Battery is charged.

To keep the battery charged, 
place it in the telephone base  
or charger when not in use.