VTech Telecommunications Ltd 80-9899-00 Benutzerhandbuch

VM991

When using your equipment, basic safety 

precautions should always be followed to reduce 

the risk of fire, electric shock and injury, including 

the following:
1.  Follow all warnings and instructions marked on 

the product.

2.  Adult setup is required.
3.  This home monitor is intended as an aid. It is 

not a substitute for home security supervision 

and should not be used as such.

4.  This product is not intended for use as a 

medical monitor.

5.  Do not use this product near water. For 

example, do not use it next to a bath tub, wash 

bowl, kitchen sink, laundry tub or swimming 

pool, or in a wet basement or shower.

6.  Use only the adapters included with this 

product. Incorrect adapter polarity or voltage 

can seriously damage the product.  

Parent unit power adapter: Input 100-240V  

AC 50/60Hz; Output: 5V DC 1.5A  

Camera unit power adapter: Input 100-240V 

AC 50/60Hz; Output: 5V DC 1500mA.

7.  The power adapter is intended to be correctly 

oriented in a vertical or floor mount position. 

The prongs are not designed to hold the plug 

in place if it is plugged into a ceiling, under-

the-table or cabinet outlet.

8.  For pluggable equipment, the socket-outlet 

(power adapter) shall be installed near the 

equipment and shall be easily accessible.

9.  Unplug this product from the wall outlet 

before cleaning. Do not use liquid or aerosol 

cleaners. Use a damp cloth for cleaning.

10. Do not cut off the power adapters to replace 

them with other plugs, as this causes a 

hazardous situation.

11. Do not allow anything to rest on the power 

cords. Do not install this product where the 

cords may be walked on or crimped.

12. This product should be operated only from the 

type of power source indicated on the marking 

label. If you are not sure of the type of power 

supply in your home, consult your dealer or 

local power company.

13. The equipment is to be supplied from an 

identified USB port complying with the 

requirements of Limited Power Source.

14. Do not overload wall outlets or use an 

extension cord.

15. Do not place this product on an unstable table, 

shelf, stand or other unstable surfaces.

16. This product should not be placed in any area 

where proper ventilation is not provided. Slots 

and openings in the back or bottom of this 

product are provided for ventilation. To protect 

them from overheating, these openings must 

not be blocked by placing the product on a 

soft surface such as a bed, sofa or rug. This 

product should never be placed near or over a 

radiator or heat register.

17. Never push objects of any kind into this 

product through the slots because they may 

touch dangerous voltage points or create a 

short circuit. Never spill liquid of any kind on 

the product.

18. To reduce the risk of electric shock, do 

not disassemble this product, but take it to 

an authorized service facility. Opening or 

removing parts of the product other than 

specified access doors may expose you to 

dangerous voltages or other risks. Incorrect 

reassembling can cause electric shock when 

the product is subsequently used.

19. You should test the sound reception every 

time you turn on the units or move one of the 

components.

20. Periodically examine all components  

for damage.

21. Be aware of possible loss of privacy while 

using public airwaves. Conversations may be 

picked up by other nursery monitors, cordless 

phones, scanners, etc.

22. Children should be supervised to ensure that 

they do not play with the product.

23. The small parts of this monitor can be 

swallowed by babies or small children. Keep 

these parts out of reach of children.

24. The product is not intended for use by persons 

(including children) with reduced physical, 

sensory or mental capabilities, or lack of 

experience and knowledge, unless they 

have been given supervision or instruction 

concerning use of the appliance by a person 

responsible for their safety.

•  Use and store the product at a temperature 

betw

een 32

o

F and 104

o

F.

•  Do not expose the product to extreme cold, 

heat or direct sunlight. Do not put the product 

close to a heating source.

•  Other electronic products may cause 

FCC Part 15
This equipment has been tested and found to comply 

with the requirements for a Class B digital device 

under Part 15 of the Federal Communications 

Commission (FCC) rules. These requirements are 

intended to provide reasonable protection against 

harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, 

there is no guarantee that interference will not occur 

in a particular installation. If this equipment does 

cause harmful interference to radio or television 

reception, which can be determined by turning the 

equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the 

following measures:

interference with your camera unit. Try 

installing your camera unit as far away from 

these electronic devices as possible: wireless 

routers, radios, cellular telephones, intercoms, 

room monitors, televisions, personal 

computers, kitchen appliances and cordless 

telephones.

pacemakers
Cardiac pacemakers (applies only to digital 

cordless devices):
Wireless Technology Research, LLC (WTR), 

an independent research entity, led a 

multidisciplinary evaluation of the interference 

between portable wireless devices and implanted 

cardiac pacemakers. Supported by the U.S. Food 

and Drug Administration, WTR recommends to 

physicians that:

Pacemaker patients
•  Should keep wireless devices at least six 

inches from the pacemaker.

•  Should NOT place wireless devices directly 

over the pacemaker, such as in a breast 

pocket, when it is turned ON.

WTR’s evaluation did not identify any risk to 

bystanders with pacemakers from other persons 

using wireless devices.

Electromagnetic fields (EMF)
This VTech product complies with all standards 

regarding electromagnetic fields (EMF). If handled 

properly and according to the instructions in this 

user’s manual, the product is safe to be used 

based on scientific evidence available today.

•  Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment 

and receiver.

•  Connect the equipment into an outlet on a circuit 

different from that to which the receiver is connected.

•  Consult the dealer or an experienced radio/TV 

technician for help.

Changes or modifications to this equipment not 

expressly approved by the party responsible for 

compliance could void the user’s authority to operate 
the equipment.
This device complies with Part 15 of the FCC rules. 
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation.
To ensure safety of users, the FCC has established 
criteria for the amount of radio frequency energy 
that can be safely absorbed by a user or bystander 
according to the intended usage of the product. This 
product has been tested and found to comply with 
the FCC criteria. The camera unit shall be installed 
and used such that parts of all persons’ body are 
maintained at a distance of approximately  
8 in (20 cm) or more.
This Class B digital apparatus complies with 
Canadian requirement: 
CAN ICES-3 (B)/NMB-3(B)

This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:  
(1) this device may not cause harmful interference, and 
(2) this device must accept any interference, including 
interference that may cause undesired operation.
The term ‘’IC:‘’ before the certification/registration 
number only signifies that the Industry Canada 
technical specifications were met.
This product meets the applicable Industry Canada 
technical specifications.

The camera unit complies with FCC RF radiation 
exposure limits set forth for an uncontrolled 
environment. The camera unit should be installed 
and operated with a minimum distance of 8 in 
(20 cm) between the main unit

 

and all persons’ 

body. Use of other accessories may not ensure 
compliance with FCC RF exposure guidelines. This 
transmitter must not be co-located or operating in 
conjunction with any other antenna or transmitter. 
This equipment complies also with Industry Canada 
RSS-210 with respect to Canada’s Health Code 6 for 
Exposure of Humans to RF Fields.