VTech Telecommunications Ltd 80-H0AU-00 Benutzerhandbuch

30

The charging base can be adapted to desktop use or mount on a standard telephone wall plate.

Turn the charging base over with the bottom side facing up. Position the mounting bracket as shown. Connect the power cord to 
the charging base and route the cord out from the large eyelet on the mounting bracket.

Insert the tabs of the mounting bracket as the direction shown below. Then tighten the screw to affix the mounting bracket.

Plug the power adapter into an electrical outlet not controlled by a wall switch.

Unplug the power adapter from the electrical outlet.
Remove the cordless handset from the charging base if necessary. On the charging base cradle, place a coin in the slit of the 
wall mount clip and rotate a half turn (180 degrees). It locks into place with the protruding edge pointing towards the upper edge 
of the charging base. This protruding edge holds the cordless handset when the phone is mounted on the wall.

Loosen the screw from the mounting bracket and remove the mounting bracket from the grooves.

Rotate the mounting bracket. Insert the tabs of the mounting bracket into the lower grooves on the charging base. Then tighten 
the screw to affix the mounting bracket.

Mount the charging base on the wall by aligning the eyelets with the mounting studs of the wall plate. Then slide the charging 
base down on both mounting studs until it locks into place.
Plug the power adapter into an electrical outlet not controlled by a wall switch. 

1.

2.

3.

1.
2.

3.

4.

5.

6.

Screw

Protruding edge

Power cord jack

Screw

Eyelets