Bird Technologies Group 61470A Benutzerhandbuch

The User Administration submenu allows the user
to enable password protection for the web-based
interface program. The boxes on this page are
interactive. To make changes click inside the box
and a cursor will appear. Refer to Figure 20. The
user is queried for a User Name and Password.
The default user name is “admin” and the default
password is “admin”. Once the correct user name
and password are entered then a menu box for cre-
ating a new user will be presented. To create a new
user enter the new user name and associated
password. Confirm the new password by entering it
again and then press the Submit button. Make sure
you write down the new user name and password
for safe keeping.

The SNMP feature is designed to provide reliable
internet notification of an alarm occurrence or a
change in operational status of the TTA system.
Simple Network Management Protocol (SNMP) is
an Internet-standard protocol for managing devices
on IP networks. In order to configure the booster as
an SNMP device the following values need to be
entered; the IP address, Authentication type, User
name (this field must have a value or traps will not
be sent), Password, Encryption type, and the
Encr yption passphrase. Figure 21 shows the
SNMP Configuration display.

The three destination IP addresses that are
entered into the table should be the IP addresses
of the computers that you want the traps to be sent
to. The destination computer must have trap
receiver software installed and running. The trap
receiver software is available for download.
Authentication type can be either none or MD5.
The User Name field must have a value entered
with the associated user name password optional.
Encryption type can be either none or MD5 with
the associated encryption passphrase as optional.
Whenever values in the SNMP Configuration
screen are changed you must click on the submit
button to save the changes.

INITIAL SETUP

When the TTA system is installed the SNMP fea-
ture should be setup for proper communications.
There are several steps required for proper setup
of the SNMP feature as listed below.

1) Connect a laptop directly to the TTA deck. Refer

to Appendix A for detailed instructions on how
to make a direct connection. The TTA deck is
shipped from the factory setup for static IP
addressing with a default IP address of
“192.168.1.1” and the factory default subnet
mask is “255.255.255.0”. Change the factory
default IP address of the TTA deck to one pro-
vided by your IT department.

Figure 21: SNMP Configuration Page.