Forward Electronics Co Ltd 44K3FDP-MS9101 Benutzerhandbuch

User Guide 

1.  Insert the receiver into USB jack of the host computer. 

2. 

Open the cover for battery cell on the mouse, and install two charged batteries into the cell, 

then close the cover of battery cell.

 

3. 

Turn the mouse down side up, and switch the button for power to “ON”.

 

4.  Start operating mouse (The operating method is the same as normal 3D optical mouse). 

5.  unable to operate mouse, please follow below steps. 

(1).Operate above 1 to 4 steps again. 

(2).Press the ID button on the receiver for 1 or 2 seconds. At this moment, the 

      LED on the receiver will flash slowly for one minute. 

(3).Please immediately press the linking button (during 1 minute) on the bottom of   

      mouse for 1 or 2 seconds. If the LED on receiver side flashes quickly for 2   

      seconds, it shows that the link is successful. If the LED on receiver side doesn’t 

      flash for 2 seconds, please repeat step (2) and (3). 

6. Trobleshooting 

(1). After mouse is installed, wireless mouse cannot operate normally or is without 

   signals. 

a.  Make sure you have connected the receiver into the computer’s USB port 

b.  Make sure you have installed the batteries correctly, and power has been switched 

on. 

c.  Establish link between the receiver and the RF function mouse. Press the connect 

ID button on the receiver first, then press the connect ID button on the RF function 

mouse.