Digital Security Controls Ltd. 13HS2HOST9 Benutzerhandbuch

2

This section describes how to set up and wire the HSM2HOST module.

Check that the following parts are in the package:
•

HSM2HOST module

•

Mounting hardware

•

Installation manual

NOTE: Permanently mount the HSM2HOST receiver and wireless devices AFTER place-
ment testing each device (section 2.3 on page 3).
Find a place that is
•

dry,

•

within operating temperature range,

•

central to the proposed placement of all wireless devices,

•

as high as possible. The range is reduced if mounted below ground level,

•

far from sources of interference, including: electrical noise (computers, televisions, 
electric motors, appliances, heating and air conditioning units), large metal objects 
like heating ducts and plumbing which may shield the electro-magnetic waves,

•

smooth and free of obstructions that block access to the rear of the unit.

Caution: Remove all power (AC, DC, telephone lines) from the system while connecting mod-
ules to the Corbus.
1.

With the alarm panel powered down, connect the HSM2HOST to the four-wire Cor-
bus of the alarm panel according to Figure 1.

2.

Once the wiring is complete, power up the security system.

The HSM2HOST can be enrolled in one of three ways:

At initial power-up of the alarm panel
When the alarm panel is powered up for the first time, a two-minute window is provided 
to enroll the first keypad or the HSM2HOST.
To enroll the HSM2HOST: 
1.

Once the HSM2HOST is wired to the alarm panel and power has been applied, power 
up a wireless keypad. 

2.

Press any button on the keypad to enroll it on the HSM2HOST. The HSM2HOST is 
then enrolled on the alarm panel.

CORBUS TO 
HSM2HOST